Methane clumped isotopes


Methane clumped isotopes are methane molecules that contain two or more rare isotopes. Methane contains two elements, carbon and hydrogen, each of which has two stable isotopes. For carbon, 98.9% are in the form of carbon-12 and 1.1% are carbon-13 ; while for hydrogen, 99.99% are in the form of protium and 0.01% are deuterium. Carbon-13 and deuterium are rare isotopes in methane molecules. The abundance of the clumped isotopes provides information independent from the traditional carbon or hydrogen isotope composition of methane molecules.

Introduction

s are molecules that have the same chemical composition, but differ only in their isotopic composition. Methane has ten stable isotopologues: 12CH4, 13CH4, 12CH3D, 13CH3D, 12CH2D2, 13CH2D2, 12CHD3, 13CHD3, 12CD4 and 13CD4, among which, 12CH4 is an unsubstituted isotopologue; 13CH4 and 12CH3D are singly substituted isotopologues; 13CH3D and 12CH2D2 are doubly substituted isotopologues. The multiple-substituted isotopologues are clumped isotopologues.
The absolute abundance of each isotopologue primarily depends on the traditional carbon and hydrogen isotope compositions of the molecules. Clumped isotope composition is calculated relative to the random distribution of carbon and hydrogen isotopes in the methane molecules. The deviations from the random distribution is the key signature of methane clumped isotope.
In thermodynamic equilibrium, methane clumped isotopologue composition has a monotonic relationship with formation temperature. This is the condition for many geological environments so that methane clumped isotope can record its formation temperature, and therefore can be used to identify the origins of methane. When methane clumped-isotope composition is controlled by kinetic effects, for example, for microbial methane, it has the potential to be used to study metabolism.
The study of methane clumped isotopologues is very recent. The first mass spectrometry measurement of methane clumped isotopologues of natural abundance was made in 2014. This is a very young and fast-growing field.
IsotopologueType of IsotopologueAbundance
12CH4Unsubstituted isotopologue98.88%
13CH4Singly-substituted isotopologue1.07%
12CH3DSingly-substituted isotopologue0.045%
13CH3DDoubly-substituted isotopologue0.000492%
12CH2D2Doubly-substituted isotopologue7.848×10−6%
13CH2D2Triply-substituted isotopologue8.488×10−8%
12CHD3Triply-substituted isotopologue6.018×10−10%
13CHD3Quadruply-substituted isotopologue6.509×10−12%
12CD4Quadruply-substituted isotopologue1.73×10−14%
13CD4Fully-substituted isotopologue1.871×10−16%

Assuming isotopes are randomly distributed throughout all isotopologues and isotopes are of natural abundance.

Notation

Δ notation

The Δ notation of clumped isotopes is an analogue to δ notation of traditional isotopes.
The notation of traditional isotopes are defined as:
is the ratio of the rare isotope to the abundant isotope in the sample. is the same ratio in the reference material. Because the variation of is rather small, in the convenience of comparison between difference samples, the notation is define as a ratio minus 1 and expressed in permil.
The Δ notation is inherited from traditional δ notation. But the reference is not a physical reference material. Instead, the reference frame is defined as the stochastic distribution of isotopologues in the sample. It means the values of Δ are to denote the excess or deficit of the isotopologue relative to the amount expected if a material conforms to the stochastic distribution.
The calculation of stochastic distribution of methane isotopologues:
where is defined as the abundance of 13CH3D molecules relative to 12CH4 molecules in random distribution; is defined as the abundance of 12CH2D2 molecules relative to 12CH4 molecules in random distribution; calculates the abundance of deuterium relative to protium in all methane molecules; calculates the abundance of carbon-13 relative to carbon-12 in all methane molecules.
For the random distribution, the probability of choosing a carbon-13 atom over a carbon-12 atom is ; the probability of choosing three protium atoms and one deuterium atom over four protium atoms is . Therefore, the probability of the occurrence of a 13CH3D molecule relative to the occurrence of a 12CH4 molecule is the product of and, which gets to. Similarly, the probability of choosing two protium atoms and two deuterium atoms over four protium atoms is. Therefore, the probability of the occurrence of a 12CH2D2 molecule relative to the occurrence of a 12CH4 molecule is, which gets to.
The calculation of deviation from the random distribution:
where the actual abundance of 13CH3D molecules relative to 12CH4 molecules, and the actual abundance of 12CH2D2 molecules relative to 12CH4 molecules are calculated as follows:
The two Δ formulas are frequently used to report the abundance of clumped isotopologues of methane.
The reason for choosing stochastic distribution as the reference frame may be historical - in the process of developing CO2 clumped isotope measurement, the only material with known clumped isotope abundance was CO2 heated to 1000oC. However, this reference frame is a good choice. Because the absolute abundance of each isotopologue primarily depends on the bulk carbon and hydrogen isotope compositions of the molecules, i.e. very close to stochastic distribution. Therefore, the deviation from the stochastic distribution, which is the key information embedded in the methane clumped isotopologues, is denoted by Δ values.

Mass-18 notation

Under some circumstances, the abundances of 13CH3D and 12CH2D2 isotopologues are only measured as a sum, which leads to the notation for isotopologues of mass-18 :
Note that is not just the sum of and.

Inferred equilibration temperature

is the inferred equilibration temperature based on values; is the inferred equilibration temperature based on values; and is the inferred equilibration temperature based on values.,, and are also called clumped-isotope temperatures. When a Δ value is smaller than zero, there is no inferred equilibration temperature associated with it. Because at any finite temperature, the equilibrium Δ value is always positive.

Physical chemistry

Equilibrium thermodynamics

When formed or re-equilibrated in reversible reactions, methane molecules can exchange isotopes with each other or with other substances present, such as H2O, H2 and CO2, and reach internal isotopic equilibrium. As a result, clumped isotopologues are enriched relative to the stochastic distribution. and values of methane in internal isotopic equilibrium are predicted and verified to vary as monotonic functions of temperature of equilibration as follows:
Δ values are in permil.
Similar relationship also applies to :
Based on these correlations,, and can be used as a geothermometer to indicate the formation temperature of methane. And the correlation of and can help to determine whether methane is formed in internal isotopic equilibrium.

Kinetic isotope effects

occurs in irreversible reactions, such as methanogenesis, and can deviate methane clumped isotopologue composition from its thermodynamic equilibrium. Normally, KIE significantly drives and lower than their equilibrium states and even to negative values.

Mixing effect

Mixing between end-members with different conventional carbon and hydrogen isotope compositions results in non-linear variations in or. This non-linearity results from the non-linear definition of and values in reference to the random distributions of methane isotopologues, which are non-linear polynomial functions of δD and δ13C values. Such non-linearity can be a diagnostic signature for mixing if multiple samples of various mixing ratios can be measured. When end-members have similar δ13C or δD compositions, the non-linearity is negligible.

Measurement techniques

Mass spectrometry

On an isotope-ratio mass spectrometer, the measurement of clumped isotopologues has to be conducted on intact methane molecules, instead of converting methane to CO2, H2 or H2O. High mass resolution is required to distinguish different isotopologues of very close relative molecular mass. Currently, two commercial models capable of such measurement are Thermo Scientific 253 Ultra and the Panorama by Nu Instruments.

Infrared spectroscopy

Tunable infrared laser direct absorption spectroscopy has been developed to measure the abundance of 13CH3D with two continuous wave quantum cascade lasers.

Theoretical studies

There have been several theoretical studies on equilibrium thermodynamics of methane clumped isotopologues since 2008. These studies are based on ab initio, from underlying physical chemistry principles, and do not rely on empirical, or lab-based, data.
Ma et al. utilized first-principle quantum mechanism molecular calculation to study the temperature dependence of the 13CH3D abundance. Cao and Liu estimated and based on statistical mechanics. Webb and Miller combined path-integral Monte Carlo methods with high-quality potential energy surfaces to more rigorously compute equilibrium isotope effects of compared to Urey model using reduced partition function ratios. Piasecki et al. performed first-principles calculations of the equilibrium distributions of all substituted isotopologues of methane.
The overall conclusion of theoretical studies is and vary as decreasing monotonic functions of temperature, and the enrichment of multiply D-substituted > multiply 13C-D-substituted > multiply 13C-substituted isotopologues for a same number of substitutions.

Distribution in nature

Geosphere

Many studies have observed composition of thermogenic methane in equilibria. The reported and are normally distributed within the range of 72 to 298 °C, which aligns well with modeled results of methane formation temperature and yield. However, some thermogenic methane samples have clumped-isotope temperatures that are unrealistically high. Possible explanations for exceedingly high clumped isotope temperatures include natural gas migration after formation, mixing effect, and kinetic isotope effect of secondary cracking.

Biosphere

is a form of anaerobic respiration used by microbes, and microbial methanogenesis can occur in deep subsurface, marine sediments, freshwater bodies, etc. It appears that methane from deep subsurface and marine sediment is generally in internal isotopic equilibrium., while freshwater microbial methanogenesis expresses large kinetic isotope effect on methane clumped isotope composition.
There are two possible explanations for this variance: firstly, substrate limitation may enhance the reversibility of methanogenesis, thus allowing methane to achieve internal isotopic equilibrium via rapid hydrogen exchange with water; secondly, activation of C-H bonds during anaerobic oxidation precedes reversibly such that C-H bonds are broken and reformed faster than the net rate of methane consumption and methane can be reequilibrated.

Experimental studies

Calibration of equilibrium thermodynamics

Theoretical calculations have predicted and values of methane in internal isotopic equilibrium. As there are assumptions and approximations in calculations, the equilibrium distribution is only experimentally validated after the analysis of samples brought to thermodynamic equilibrium. Nickel and platinum catalysts have been used to equilibrate methane C-H bonds at various temperatures from 150 to 500 °C in laboratory. Currently, catalytic equilibration is also the practice to develop the reference material for clumped isotope analysis.

Microbial culture

ic methanogens utilize CO2 and H2 to produce methane by the following reaction:
Acetoclastic methanogens metabolize acetate acid and produce methane:
In laboratories, clumped isotope compositions of methane generated by hydrogenotrophic methanogens, acetoclastic methanogens, and methylotrophic methanogens are universally out of equilibria. It has been proposed that the reversibility of methanogenic enzyme is key to the kinetic isotope effect expressed in biogenic methane.

Pyrolysis of larger organic molecules

Both pyrolysis of propane and closed-system hydrous pyrolysis of organic matter generate methane of consistent with experimental temperatures. Closed-system nonhydrous pyrolysis of coal yields non-equilibrium distribution of methane isotopologues.

Sabatier reaction

Methane synthesized by Sabatier reaction is largely depleted in CH2D2 and slightly depleted in 13CH3D relative to the equilibrium state. It has been proposed that quantum tunneling effects result in the low observed in the experiment.

Applications

Distinguishing origins of natural gas

Biogenic, thermogenic and abiotic methane is formed at different temperatures, which can be recorded in clumped isotope compositions of methane. Combined with conventional carbon and hydrogen isotope fingerprints and gas wetness, methane clumped isotope can be used to identify the origins of methane in different types of natural gas accumulations.

Biogeochemistry of microbial methane

In freshwater environments, significant kinetic isotope effect leads to a wide range of observed ' and ' values, which has the potential to provide insights into methanogenesis rate and chemical condition in the corresponding environments.