Xcelerator


Xcelerator is a steel launched roller coaster at Knott's Berry Farm in Buena Park, California. It was Intamin's first hydraulically launched coaster, while also the fourth Intamin installation at Knott's, alongside The Sky Cabin, Bigfoot Rapids and Perilous Plunge.

History

In December 2001, Knott's Berry Farm announced that Xcelerator would be added to the park. The ride opened on June 22, 2002.
Xcelerator was standing but not operating between July 2017 and March 24, 2018.

Ride experience

Xcelerator's powerful hydraulic catapult motor accelerates the train from 0 to in 2.3 seconds. It only uses of track to launch the train. The twin hydraulic catapult motor achieves a maximum of each while accelerating the train. Xcelerator's hydraulic motor system has the mechanical capability of accelerating vehicles to a speed of or more, though it only needs to hit for the train to crest the hill. In order for a train to launch, the train must "drift" back to "hook" on to a catch car. Twenty-four volts are used to demagnetize a pin underneath the third car, which causes it to drop. At the same time, two bellows actuators fill up with air. Meanwhile, near the back of the train, two drive tires that are holding the train in place begin to retract. The brakes will lower while the train rolls back to hook into the catch car—which is over long. Once connected the motor will engage to launch the train. The catch car passes over its own set of magnetic brakes to retard it. The motor has to work harder to attain launch speed if the train is not loaded with enough riders. On occasion, the catch car can overshoot its end position if it cannot attain the proper speed within set parameters, which causes it to stall near the end of the launch track. The train must also clear the launch track within three seconds. If it does not the ride will shut down. From the time the launch begins, the train has 8.25 seconds to pass over a proximity switch near the bottom of the first drop which clears the starting block. If the train does not pass over the switch within the given time frame, the ride will shut itself down.
After the launch the train crests a vertical top hat element, then soars through a and over banked turns and glides to a smooth stop though brake run and returns to the station house. The magnetic braking system consists of mounted magnetic clippers on the trains and copper alloy fins mounted onto the track. The alloy fins on the launch section retract during the launch procedure so as to not interfere with the train. In a case of a rollback, the magnetic brakes retard the train. They are raised section by section after the train has passed over them. The brake fins on the brake run are stationary and cannot be lowered. The train is traveling at approximately when entering the brake run.

Trains

Xcelerator features two trains: red and violet. The trains themselves have spring-loaded wheel assemblies and are standard Intamin trains with specially crafted shells to make them look like 1957 Chevrolet Bel Air convertibles. The red train was accidentally painted with its color scheme reversed when the ride opened. It featured a yellow color scheme with red flames in the front and side, instead of a red train with yellowish flames. During one of the ride's rehabs, the color scheme was corrected by repainting the red train with orange flames added to the front and sides. After an accident in 2009, the red train now features patriotic blue flames. Each train is five cars long and holds twenty passengers. A maximum of two trains can operate at any given time. However, the two train operation is only slightly more efficient than only using one train. Therefore, Xcelerator usually only operates with one train regardless of the number of people in the park. Instead, each train is used by itself for about a year, while the other is undergoing maintenance. When maintenance is completed on one of the trains, it is returned to active duty and the other train is sent to maintenance.

Restraints

Xcelerator's trains use hydraulically operated T-Bar lap bar restraints. These restraints are featured on Intamin's earlier accelerator coaster models. However, over-the-shoulder restraints are now used on the newer models due to safety concerns. Xcelerator also had special light meters installed on the restraints. The meter must show all green in order for a guest to ride. If the meter shows red then the guest cannot ride. Eventually the meter system was removed and the park now uses black lines etched on the side of each restraint. The black line must pass a certain part of the seat frame in order for the guest to ride. The ride also has seat belts that must be buckled before an operator pulls down the lap bar. Failure to do so slows the load time considerably. Another contributing factor involving the seat belts and a guest not being able to ride is requirement of one inch of slack must be pulled from the seat belt.

Limitations

Rollbacks

Occasionally, a train will not attain enough speed to make it over the initial top hat element. Instead, the train will partially ascend the tower, stall and then roll back into magnetic brake fins situated on the launch track. This is known as a rollback and is part of the normal design of the ride. A rollback can cause the ride to close for an indefinite amount of time while the ride is reset and a sufficient number of test launches are performed. Rain, weight, frequency of launching, outside temperature, and overheating can contribute to a rollback.

Weather

The ride will not operate in the rain, even during drizzling conditions. This is to prevent rollbacks due to hydroplaning on the launch track. The track usually needs to dry until maintenance has cleared it to operate again before the first test launch is made. This is to reduce the chance of a rollback as well as preventing accidents.

Progression to taller and faster rides with inversions

Xcelerator laid the groundwork for taller and faster rides such as Top Thrill Dragster at Cedar Point and Kingda Ka at Six Flags Great Adventure, coasters both passing the mark and mark. Xcelerator also laid the groundwork for rides featuring inversions, such as Storm Runner at Hersheypark, which has banked inversions, and Kanonen at Liseberg, which featured a vertical loop.
While Xcelerator set a successful example for such rides, modifications were made to the larger models. Storm Runner and Kingda Ka use dual loading stations to speed up dispatching times, as well as larger and more-powerful motors.
Lower-powered coasters have been built as well, such as Rita at Alton Towers.

Incidents