Teller mine


The Teller mine was a German-made antitank mine common in World War II. With explosives sealed inside a sheet metal casing and fitted with a pressure-actuated fuze, Teller mines had a built-in carrying handle on the side. As the name suggests the mines were plate-shaped.
Containing little more than 5.5 kilograms of TNT and a fuze activation pressure of approximately, the Teller mine was capable of blasting the tracks off any World War II-era tank or destroying a lightly armored vehicle. Because of its rather high operating pressure, only a vehicle or heavy object passing over the Teller mine would set it off.
Of the two types of pressure-fuze available for Teller mines, the T.Mi.Z.43 fuze was notable for featuring an integral anti-handling device as standard: when the T.Mi.Z.43 fuze is inserted and the pressure plate is screwed down into place, it shears a weak arming pin inside the fuze with an audible "snap". This action arms the anti-handling device. Thereafter, any attempt to disarm the mine by unscrewing the pressure plate to remove the fuze will automatically release the spring-loaded firing pin inside it, triggering detonation.
Since it is impossible to determine which fuze type has been installed, no pressure plate or screw cap should ever be removed from a Teller mine. The T.Mi.Z.43 fuze can be fitted to the Teller mine 35, 42 and 43 series.
To hinder demining, all Teller mines featured two additional fuze wells to enable anti-handling devices to be attached, typically some form of pull-fuze.
There were four models of Teller Mine made during World War II:
Approximately 3,622,900 of these mines were produced by Germany from 1943 to 1944.

Gallery