Signal-to-noise and distortion ratio is a measure of the quality of a signal from a communications device, often defined as where is the average power of the signal, noise and distortion components. SINAD is usually expressed in dB and is quoted alongside the receiver RF sensitivity, to give a quantitative evaluation of the receiver sensitivity. Note that with this definition, unlike SNR, a SINAD reading can never be less than 1. When calculating the distortion, it is common to exclude the DC components. Due to widespread use, SINAD has collected several different definitions. SINAD is commonly defined as:
The ratio of total received power, i.e., the signal to the noise-plus-distortion power. This is modeled by the equation above.
The ratio of the power of a test signal, i.e. a sine wave, to the residual received power, i.e. noise-plus-distortion power. With this definition, it is possible to have a SINAD level less than one. This definition is used in the calculation of ENOB for DACs and ADCs.
Information on the relations between SINAD, ENOB, SNR, THD and SFDR can be found in.
A typical example, quoted from a commercial hand heldVHF or UHF radio, might be: This is stating that the receiver will produce intelligible speech with a signal at its input as low as 0.25 μV. Radio receiver designers will test the product in a laboratory using a procedure, which is typically as follows:
With no signal present on the input, the noise and distortion of the receiver are measured at a convenient level.
A signal is applied to the input such that the output increases by 12 dB.
The level of the signal needed to produce this is noted. In this case, it was found to be 0.25 microvolts.
According to the radio designer, intelligible speech can be detected 12 dB above the receiver's noise floor. Regardless of how accurate this output power is regarding intelligible speech, having a standard output SINAD allows easy comparison between radio receiver input sensitivities. This 0.25 μV value is typical for VHF commercial radio, while 0.35 μV is probably more typical for UHF. In the real world, lower SINAD values can still result in intelligible speech, but it is tiresome work to listen to a voice in that much noise.
