SCSI high byte termination


In SCSI computer systems, there is a special case with mixed 8-bit and 16-bit devices where high-byte termination may be required.
Most parallel SCSI buses are terminated at each end. However where the bus width is not constant, it is sometimes necessary to provide special termination for the high byte and the associated parity bit. This high-byte termination can use standard SCSI termination techniques, such as a passive terminator, active terminator, or a forced-perfect terminator. This diagram shows a typical SCSI high-byte termination scheme:
There is a simplification to this which is sometimes used in the case where there is only one 16-bit device connected to one or more 8-bit devices. Then it is possible to wire all the eight spare data bits and the ninth parity bit together and to terminate them with a single resistor circuit to TERMPOWER. So in the case of a differential SCSI bus, it is possible to terminate all 18 spare signal wires with just one resistor. This method is not considered good practice, but has been successfully used in some SCSI products.