Riverstone Networks, was a provider of networking switching hardware based in Santa Clara, California. Originally part of Cabletron Systems, and based on an early acquisition of YAGO, it was one of the many Gigabit Ethernet startups in the mid-1990s. It is now a part of Alcatel-Lucent and its operations are being wound down via a Chapter 11 filing by their current owners.
1 December 2006 - Lucent Technologies completed the process of a merger of equals with Alcatel. Assets of Riverstone Networks are now part of Alcatel-Lucent
Products
All of Riverstone Networks products were geared towards IP over Ethernet, often for a Metro Ethernet solution. All the products were multilayer switches and specialized in MPLSVPNs.
15000 Family
The 15000 Family differed from the RS family as the 15K is not flow-based. Flow-based routers use the main CPU to process new flows and packets through the switch. The 15K differed by letting the line card processors do the work for the network traffic, leaving the main CPU to work on the system itself. This type of network processing is similar to Cisco's dCEF. The 15K products were based on a different operating system than other Riverstone products, called ROS-X. It was designed to be modular and more like the common command line interface of Cisco.
15008 - The highest performance product from Riverstone. It supported a 96 port 10/100 Ethernet card, 12 or 24 port 1GB Ethernet cards and 1 or 2 port 10GB Ethernet cards. Support for ATM and PoS was planned.
15100/15200 - Designed with the same architecture and operating system as the 15008, the 15100 and 15200 were designed more for an access/distribution network role. They were semi-modular in design with some fixed 1G Ethernet ports and GBIC uplinks for either 1GB or 10GB.
RS Family
The RS family of products were flow-based multilayer switches. They ran ROS software, which had a command line interface but could also be configured via SNMP.
1x00 - Fixed hardware configuration
3x00 - Semi-modular in design, came with 32 fixed 100BaseT Ethernet ports and 2 modular bays
8x00 - Fully modular hardware, came in either 8 slot or 16 slot versions. The modules for the 8x00 included Control Modules, 100BaseT Ethernet, 1000BaseT Ethernet, 1000BaseX GibabitEthernet with interchangeable GBICs, including PoS, ATM, Serial, T1/E1, and T3/E3.
38000 - Fully modular hardware, differed from the rest of the RS range physically due to the modular slots being vertical.
ES Family
ES 2010 - Fixed 24 10/100 port multilayer switch designed for network access/network edge role. It had two GBIC ports for 1G Ethernet uplinks. The ES range did not support WAN ports or MPLS.
