Reapportionment Act of 1929
The Reapportionment Act of 1929 was a combined census and apportionment bill passed by the United States Congress on June 18, 1929, that established a permanent method for apportioning a constant 435 seats in the U.S. House of Representatives according to each census.
This reapportionment was preceded by the Apportionment Act of 1911 and took effect after the 1932 election meaning that the House was never reapportioned as a result of the 1920 United States Census. Representation in the lower chamber remained frozen for twenty years.
However, like earlier Apportionment Acts, the 1929 Act neither repealed nor restated the requirements of the previous apportionment acts that congressional districts be contiguous, compact, and equally populated. It was not clear whether these requirements were still in effect until in 1932 the Supreme Court of the United States ruled in that the provisions of each apportionment act affected only the apportionment for which they were written. Thus the size and population requirements, last stated in the Apportionment Act of 1911, expired with the enactment of the 1929 Act. The 1929 Act gave little direction concerning congressional redistricting. It merely established a system in which House seats would be reallocated to states which have shifts in population. The lack of recommendations concerning districts had several significant effects. The Reapportionment Act of 1929 allowed states to draw districts of varying size and shape. It also allowed states to abandon districts altogether and elect at least some representatives at large, which several states chose to do, including New York, Illinois, Washington, Hawaii, and New Mexico. For example, in the 88th Congress 22 of the 435 representatives were elected at-large.
Historical context
, Section 2, Clause 3 of the United States Constitution requires that seats in the United States House of Representatives be apportioned among the various states according to the population disclosed by the most recent decennial census, but only counting three-fifths of the slave population until the Fourteenth AmendmenWith but one exception, the Apportionment Act of 1842, Congress enlarged the House of Representatives by various degrees following each subsequent census until 1913, by which time the membership had grown to 435. From the 1790s through the early 19th century, the seats were apportioned among the states using Jefferson's method. In 1842, the House was reduced from 242 to 223 members by the incoming Whig Party, which had ousted the Jacksonian Democrats. The Act of 1842 also contained an amendment which required single-member district elections rather than at-large elections within a state, prompting backlash against an increase in Congressional power.
In 1842 the debate on apportionment in the House began in the customary way with a jockeying for the choice of a divisor using Jefferson's method. On one day alone, 59 different motions to fix a divisor were made in a House containing but 242 members. The values ranged from 30,000 to 140,000 with more than half between 50,159 and 62,172. But the Senate had tired of this approach and proposed instead an apportionment of 223 members using Webster's method. In the House John Quincy Adams urged acceptance of the method but argued vehemently for enlarging the number of members, as New England's portion was steadily dwindling.
From 1842 through the 1860s, the House increased minimally at each census and as new states were admitted to the union. But the Fourteenth Amendment dramatically increased the apportionment population of the Southern states because the black population counted fully instead of being reduced to three-fifths its numbers. As a result, a major increase in seats was needed to keep about the same number of seats in the northern states and the House was enlarged by 50 seats in respect of the 1870 census. The reapportionment of 1872 created a house size of 292. No particular apportionment method was used during the period 1850 to 1890, but from 1890 through 1910, the increasing membership of the House was calculated in such a way as to ensure that no state lost a seat due to shifts in apportionment population. In 1881, a provision for equally populated contiguous and compact single member districts was added to the reapportionment law, and this was echoed in all decennial reapportionment acts through to 1911.
Then, in 1920, the Republicans removed the Democrats from power, taking the presidency and both houses of Congress. Due to increased immigration and a large rural-to-urban shift in population from 1910 to 1920, the new Republican Congress refused to reapportion the House of Representatives because such a reapportionment would have shifted political power away from the Republicans. A reapportionment in 1921 in the traditional fashion would have increased the size of the House to 483 seats, but many members would have lost their seats due to the population shifts, and the House chamber did not have adequate seats for 483 members. By 1929, no reapportionment had been made since 1911, and there was vast representational inequity, measured by the average district size; by 1929 some states had districts twice as large as others due to population growth and demographic shift.
As an example, the city of Detroit doubled in population between the 1910 and 1920 censuses. Since the House was not reapportioned, the city had just two congressmen representing 497,000 people each. The average congressional district in 1920 had only 212,000. By the end of the decade things had grown worse. One Detroit congressman represented 1.3 million people while some rural districts in Missouri had fewer than 180,000 people.
Impact
The Reapportionment Act of 1929 capped the number of representatives at 435, where it has remained except for a temporary increase to 437 members upon the 1959 admission of Alaska and Hawaii into the Union.As a result, the average size of a congressional district has tripled in size—from 210,328 inhabitants based on the 1910 Census, to 710,767 according to the 2010 Census. Additionally, due to the unchanging size of the House, combined with the requirement that districts not cross state lines, and the population distribution among states in the 2010 Census there is a wide size disparity among congressional districts: Montana has the largest average district size, with 994,416 people; and Rhode Island has the smallest, with 527,624 people.
Since 1941, seats in the House have been apportioned among the states according to the method of equal proportions. Implementation of this method has eliminated debates about the proper divisor for district size; any divisor that gives 435 members has the same apportionment. It created other problems however, because, given the fixed-size House, each state's congressional delegation changes as a result of population shifts, with various states either gaining or losing seats based on census results. Each state is then responsible for designing the shape of its districts.