Pilot signal


In telecommunications, a pilot signal is a signal, usually a single frequency, transmitted over a communications system for supervisory, control, equalization, continuity, synchronization, or reference purposes.

Uses in different communication systems

FM Radio

In FM stereo broadcasting, a pilot tone of 19 kHz indicates that there is stereophonic information at 38 kHz. The receiver doubles the frequency of the pilot tone and uses it as a frequency and phase reference to demodulate the stereo information.
If no 19 kHz pilot tone is present, then any signals in the 23-53 kHz range are ignored by a stereo receiver. A guard band of ±4 kHz protects the pilot tone from interference from the baseband audio signal and from the lower sideband of the double sideband stereo information. The third harmonic of the pilot is used for Radio Data System.

AM Radio

In AM stereo, the bandwidth is too narrow to accommodate subcarriers, so the modulation itself is changed, and the pilot tone is infrasonic at a frequency of 25 Hz.

Television

In some color television standards, the color burst placed after every sync pulse on visible lines is the pilot signal to indicate that there are color subcarriers present and allow synchronizing the phase of the local oscillator in the demodulation circuitry. However, SECAM features continuous subcarriers which don't need their phase tracked due to being frequency-modulated as compared to the QAM approach of the other systems, thus making it unnecessary.
In the NTSC television system, a pilot tone of 15.7342657 kHz is used to indicate the presence of MTS stereo.

Video Recording

In some analog video formats frequency modulation is the standard method for recording the luminance part of the signal, and is used to record a composite video signal in direct color systems, e.g. Video 2000 and some Hi-band formats a pilot tone is added to the signal to detect and correct timebase errors.

Cable

In cable service plant infrastructures, two or more pilot frequencies are used to allow network amplifiers to automatically adjust their gain over temperature swings. This is done by the amplifiers having special circuitry that track the frequencies in order to maintain a consistent gain. Without this capability, network amplifiers may drive the signal too strong or too weak; thus requiring constant adjustment. Pilot frequencies can either be generated via an agile modulator, taking the space of analog NTSC channels; or be generated by dedicated equipment. Sometimes it is necessary to employ several independent pilot frequencies. Most radio relay systems use radio or continuity pilots of their own but transmit also the pilot frequencies belonging to the carrier frequency multiplex system.