Phospholipid-derived fatty acids are widely used in microbial ecology as chemotaxonomic markers of bacteria and other organisms. Phospholipids are the primary lipids composing cellular membranes. Phospholipids can be saponified, which releases the fatty acids contained in their diglyceride tail. Once the phospholipids of an unknown sample are saponified, the composition of the resulting PLFA can be compared to the PLFA of known organisms to determine the identity of the sample organism. PLFA analysis may be combined with other techniques, such as stable isotope probing to determine which microbes are metabolically active in a sample. PLFA analysis was pioneered by D.C. White at the University of Tennessee, in the early to mid 1980s.
Phospholipid fatty acid analysis
PLFAs are an essential structural component of all microbial cellular membranes. PLFA analysis is a technique widely used for estimation of the total biomass and to observe broad changes in the community composition of the living microbiota of soil and aqueous environments. There has been a surge of interest in PLFAs in recent years, evident from the large increase in peer-reviewed journal references on the subject. However, there is increasing concern that some researchers are assigning PLFAs to specific microbial classes when in fact those PLFAs are present in a broad range of life forms. Phospholipids can occur in many biological classes, so care has to be taken in over-assigning PLFA biomarkers to the wrong class. Even though phospholipids occur in many different life forms, the fatty acid side chains between differing life forms can be quite unique. Polyunsaturated fatty acids are found in plants, algae and cyanobacteria, but are often not present in bacteria. Monounsaturated fatty acids, odd-chain saturated fatty acids, branched-chain fatty acids and cyclopropane fatty acids are mostly synthesized by bacteria. The polyunsaturated fatty acid, 18:2 ω6c, is found in soil fungi, whereas the monounsaturated fatty acid, 16:1 ω5c, is predominant in Arbuscular mycorrhizal fungi. The basic premise is that as individual organisms die, phospholipids are rapidly degraded and the remaining phospholipid content of the sample is assumed to be from living organisms. As the phospholipids of different groups of bacteria and fungi contain a variety of somewhat unusual fatty acids, they can serve as useful biomarkers for such groups. PLFA profiles and composition can be determined by purifying the phospholipids and then cleaving the fatty acids for further analysis. Knowledge of the composition and metabolic activity of the microbiota in soils, water and waste materials is useful in optimizing crop production, in bioremediation and in understanding microbial ecosystems. Soil microbial community analysis by PLFA has been a widely used technique due to the sensitive, reproducible measurement of the dominant portions of the soil microbiota and the fact that PLFA does not require cultivation of the organisms. Sampling of soil populations by culturing has proven not cost effective and results in biased results due to the differing ease of culturing of some organisms. The main drawback of PLFA has been that the extraction time is very long and cumbersome. A new 96-well plate PLFA extraction procedure has been developed which represents a 4-to-5 fold increase in throughput over traditional PLFA extraction methods. This new method, coupled to new software tools for analyzing the PLFA data, will be useful to laboratories performing large numbers of PLFA analyses, or for laboratories wanting to begin PLFA research.
Early studies of the living soil microbial communities were largely based on attempts at culturing bacteria and fungi of soil. However, due to difficulty in culturing many of the organisms, the differential growth rates of the organisms, and labor involved, this proved to be not satisfactory. A 1965 article proposed using molecules produced by the organisms as biomarkers for the microbial communities. In the following two decades, rapid progress was made in development of gas chromatographs and of fused silica capillary columns for the GC instruments, enabling better analysis of biological materials, including fatty acid methyl esters. PLFA analysis can be used for microbial community structure and activity through the use of “signature” fatty acids. The basic concept is that the phospholipid content represents living organisms as these compounds are rapidly decomposed in aerobic mixed communities and that some of the neutral lipid components such as the lipopolysaccharides of Gram-negative bacteria do not reflect organisms alive at the time of sampling.
PLFA sample preparation
Although the method of sample collection is different for soil, water samples, etc., the extraction-derivatization is generally similar to the following protocol from an article on soil microbial communities. The lipids were extracted from the dried soil sample by use of a chloroform-methanol-phosphate buffer mixture by use of a brief sonication followed by shaking for 2 hours and centrifugation to pellet the soil material. The liquid above the soil had additional chloroform and water added to cause separation of the lipid-containing chloroform from the buffer/methanol phase. The lipids were fractionated on a solid-phase extraction column and the neutral lipids, free fatty acids and other materials discarded and the phospholipid phase then dried, prior esterification to form the fatty acid methyl esters to make them suitable for analysis.
Analysis of FAMEs
Gas chromatography analysis of fatty acid methyl esters is the method of choice for analysis of PLFAs from soil. The GC is coupled with either a mass spectrometer detector or a flame ionization detector. The GC-MSD system is more expensive to purchase and maintain, requires considerable skill to operate, and is typically used for qualitative analysis only. Identification of fatty acids using the GC-FID system is typically use for both qualitative and quantitative analysis of FAMEs, and is usually dependent on comparison of retention times of the unknown fatty acid compounds in comparison to purchased FAME standards. A commercially available, fatty-acid based microbial identification system, which reproducibly names and quantitates the FAMEs, has been widely adopted for PLFA analysis.
The PLFA components of soil microbiota
are Gram-positive bacteria that are some of the most common bacteria in soil, freshwater and marine environments. Actinomycetes are active in decomposition of organic matter and give rise to the rich "earthy" smell of freshly tilled soils. This group of bacteria produce distinctive biomarker fatty acids having a methyl branch at the 10th carbon, such as 16:0 10-methyl and 18:0 10-methyl. Some common species of soil actinomycetes include Rhodococcus, Nocardia, Corynebacterium, and Streptomyces. Gram-positive bacteria include aerobic Bacillus species especially those related to B. cereus and to B. subtilis. These bacteria are common in the bulk soil and increase in numbers in the rhizosphere. The PLFA profiles of these Gram-positive species have high percentages of biomarker branched-chain fatty acids such as 15:0 iso and 15:0 anteiso. Thus, the sum of the iso and anteiso fatty acids in a PLFA analysis may provide an estimate of the abundance of the Gram-positive bacteria in the sample. Gram-negative bacteria are a major component of the plant rhizosphere and improve plant growth by increasing solubility of phosphate, producing ionophore compounds that increase uptake of iron or other minerals and may produce antifungal compounds. Gram-negative bacteria produce high levels of monounsaturated fatty acids during active metabolism but convert much of the unsaturated fatty acid composition to cyclopropane fatty acids when metabolism and cell division slow due to shortage of nutrition or other stress. Thus, in PLFA analysis, the sum of monounsaturated and cyclopropane fatty acids may provide an estimate of the abundance of Gram-negative bacteria. A high ratio of cyclopropane to monounsaturated fatty acid indicates stress conditions. Anaerobic bacteria in agriculture are primarily a factor in soils of low oxygen levels such as occur in greater depths or of wet conditions such as in rice paddies. Using PLFA analysis in early sampling, the bacteria- archaea consortia in rice paddy soil was about 44% aerobic bacteria, 32% facultatively anaerobic- bacteria and 24% archaea. Under longer term flooding, the levels were 27%, 36% and 37% respectively and with total biomass being significantly lower. Dimethyl acetals formed during derivatization are considered to be biomarkers of anaerobic bacteria. Archaea are universally distributed in soils and have been shown to control nitrification in acidic conditions and to contribute to ammonia oxidation in agricultural and forest soils. However, as the phospholipids of archaea are not ester linked as in bacteria, but are ether linked, they are not significantly present in routine PLFA sample preparation which is designed to cleave ester-linked fatty acids. Arbuscular mycorrhizae fungi penetrate the walls of cortical cells of about 80% of all vascular plant families, generating a symbiotic relationship. The fungi form membrane structures adjacent to the plant cell membrane allowing exchange of phosphorus, nitrogen compounds and minerals from the fungus and the plant provides the fungus primarily with photosynthesis-derived sugars. As the AMF are obligate symbiotic fungi, they are not free-living in the soil. The AMF hyphae in the root form lipid materials which then are transported to the hyphae that extend into the soil from the root and thus may occur in a soil sample. Vesicles are lipid storage organs of AMF and these and the hyphae in the soil contain the fatty acids 18:2 w6c as well as containing the fatty acid 16:1 w5c which has been recommended as a biomarker for AMF.
Applications of PLFA analysis
Sampling of agricultural soils for analysis of chemical composition has long been practiced in crop production and while there has been recognition of the importance of the soil microbiota, tools for studying the microbiota have been developed relatively recently.
High value vegetable crops
Many high-value vegetable crops easily justify soil testing both for chemical content and the soil microbiota. Conventional, low-input and organic farming systems showed a rapid response of the soil microbial communities to wet/dry cycles and that increases in bacterial cyclopropyl fatty acids were useful to detect periods of stress. Lines of transgenic corn expressing Bacillus thuringiensis endotoxins were found to have small effect on soil microbial communities when compared by PLFA analysis to their non-transgenic isolines. Successful exotic invasive plant species can have profound effects on the microbial communities of the soil perhaps thus improving their competitiveness. Grassland restoration practices of tillage, weeding and herbicide use showed an impact on microbial communities of the upper soil but very small changes on the microbiota of lower soil layers and that after 4 years of recovery the communities were very similar to untreated plots.
Bioremediation
has been studied using PLFA analysis of soil microbiota from sites contaminated by diesel oil, crude oil, explosives, olive mill waste, pentachlorophenol, coal tar and PCBs. There are reports of the effects on PLFAs of heavy metals on arbuscular fungi and on bacteria, of polycyclic aromatic hydrocarbons on rice paddy bacteria and of methylene chloride on bacteria.
Phytoplankton
are microscopic photosynthesizing plants that inhabit the sunlit layers of oceans and bodies of freshwater. As the primary source of elaborated carbon compounds, they are vital to the aquatic food web. Phytoplankton produce considerable amounts of polyunsaturated fatty acids, including Eicosapentaenoic acid, with microalgae being the origin of omega-3 fatty acids in fish oil. The diverse taxonomic groups in algae vary in abundance dependent on environmental conditions such as temperature, salinity, sunlight, and nutrient availability. The PLFA biomarker compositions were found to enable determination of the prevalence of the major groups in several marine environments. In a study of reservoir sedimentary deposits, an assumption was made that the community PUFA content constituted ca. 50% of the total microeukaryotic PLFAs. It was also assumed that "The ratio of omega-3 to omega-6 fatty acids describes the relative contribution of phototrophic to heterotrophic members of the microeukaryotic community…."
Aquatic environments
In contrast to the considerable microbial diversity in soils, free-living microbes distributed by marine currents and exposed to algal exudates exhibit global distributions for a few dominant microbial groups of relatively few species. Streambed sediments displayed a variation in microbial community structure related to the forest environment and geographic location of the stream, with much of the variation determined by use of the algal biomarker fatty acid 18:3 w3. By PLFA analysis, considerable spatial and seasonal variations were determined in a freshwater reservoir sedimentary microbial community.
Forestry
s are dependent on available nutrients in soil rather than agricultural fertilizers and thus are routinely colonized by symbiotic mycorrhizal fungi. The mycorrhizae may be ectomycorrhizae and/or arbuscular in type in the forest. The amount of total PLFA in soil provides an estimate of the total soil fungi. The AMF can be estimated by the amount of 16:1 w5c fatty acid in the PLFA. Water stress was indicated by an increase in in a Douglas fir forest. Boreal forests with low soil pH values had elevated EM PLFAs and raising the pH of the soil increased bacterial PLFAs. The introduction of photosynthates through tree roots is a major source of carbon for soil microbiota and influences the composition of fungal and bacterial communities. Forest areas without tree roots had less fungal biomarkers and more actinobacterial biomarkers than areas with tree roots. Addition of nitrogen fertilizer to an oak forest reduced the ectomycorrhizal fungal content of the soil microbiota.
Composting
of organic materials is the microbial degradation of heterogeneous organic material under moist, self-heating, aerobic conditions. Initially, activity by mesophilic organisms leads to a rapid rise in temperature, followed by thermophilic organisms dominating the degradation process leading to a cooling period in which mesophilic bacteria again dominate populations. A commercial FAME extraction protocol developed for identification of bacteria, a mild alkaline methanolysis protocol and PLFA-extraction/derivatization were compared for effectiveness. The PLFA protocol gave the most detailed information about community succession, however, the other two protocols were much simpler and appeared suitable for analysis of microbial FAME profiles in compost.
Wastewater treatment
technology is the most widely used method for wastewater treatment. Complex microbial communities in activated sludge processes are needed for the stable removal efficiency of organic pollutants. PLFA analysis can be used to monitor the microbial community composition of activated sludge reactors, which microbial groups are predominant, and the efficiency of such systems.
