A structural trap is a type of geological trap that forms as a result of changes in the structure of the subsurface, due to tectonic, diapiric, gravitational and compactional processes.
Anticlinal trap
An anticline is an area of the subsurface where the strata have been pushed into forming a domed shape. If there is a layer of impermeable rock present in this dome shape, then hydrocarbons can accumulate at the crest until the anticline is filled to the spill point - the highest point where hydrocarbons can escape the anticline. This type of trap is by far the most significant to the hydrocarbon industry. Anticline traps are usually long oval domes of land that can often be seen by looking at a geological map or by flying over the land.
Fault trap
This trap is formed by the movement of permeable and impermeable layers of rock along a fault plane. The permeable reservoir rock faults such that it is now adjacent to an impermeable rock, preventing hydrocarbons from further migration. In some cases, there can be an impermeable substance smeared along the fault surface that also acts to prevent migration. This is known as clay smear.
Stratigraphic trap
In a stratigraphic trap, the geometry allowing the accumulation of hydrocarbons is of sedimentary origin and has not undergone any tectonic deformation. Such traps can be found in clinoforms, in a pinching-out sedimentary structure, under an unconformity or in a structure created by the creep of an evaporite.
Masses of salt are pushed up through clastic rocks due to their greater buoyancy, eventually breaking through and rising towards the surface. This salt is impermeable and when it crosses a layer of permeable rock, in which hydrocarbons are migrating, it blocks the pathway in much the same manner as a fault trap. This is one of the reasons why there is significant focus on subsalt imaging, despite the many technical challenges that accompany it.
Unconformity
Hybrid trap
Hybrid traps are the combination of two types of traps. In the case of tilted blocks, the initial reservoir geometry is the one of a fault-controlled structural trap but the caprock is generally made by the draping sedimentation of mudstones during the oceanisation process.
