PPS submachine gun


The PPS is a family of Soviet submachine guns chambered in 7.62×25mm Tokarev, developed by Alexei Sudayev as a low-cost personal defense weapon for reconnaissance units, vehicle crews and support service personnel.
The PPS and its variants were used extensively by the Red Army during World War II and were later adopted by the armed forces of several countries of the former Warsaw Pact as well as its many African and Asian allies.

History

The PPS was created in response to a Red Army requirement for a compact and lightweight weapon with similar accuracy and projectile energy to the Soviet PPSh-41 submachine gun widely deployed at the time, with reduced rate of fire, produced at lower material cost and requiring fewer man-hours, particularly skilled labour.
Sudayev was ordered by the State Commission for Armaments to perfect for large-scale production the sub-machine gun design of Lieutenant I.K. Bezruchko-Vysotsky from the Dzerzhinsky Artillery Academy, who had created two prototypes in 1942; the second of these was the basis of Sudayev's gun.
During design, emphasis was placed on simplifying production and eliminating most machining operations; most of the weapon's parts were sheet-steel stamped.
These measures reduced the number of machined components to a bare minimum, cutting down machining time by more than half, to 2.7 hours of machining instead of 7.3 hours for the PPSh-41. There were also savings of over 50% in raw steel usage, down to 6.2 kg instead of 13.9 kg, and fewer workers were required to manufacture and assemble the parts. Thanks to the improvements in production efficiency, the Soviet planners estimated that the new gun would have allowed an increase in monthly submachine gun output from 135,000 units to 350,000 weapons.
Prototypes were field tested between 26 April and 12 May 1942; the evaluation commission's report was largely favorable, but still proposed some minor improvements mostly aimed at strengthening the gun's structure. By July, Shpagin had finished his own improved model, and it was pitted in field trials against the PPS, which was found superior in most respects: accuracy, reliability, maneuverability.. The weapon was put into small-scale production during the Siege of Leningrad; mass production did not commence until early 1943 at the Sestroretsk Arsenal. The factory in charge for the pilot production starting in December 1942 was the Sestroretsk Tool Factory The first series guns were presented for personal inspection to Andrei Zhdanov and Leonid Govorov in the same month. The full-scale production began in 1943, and the official count of PPS-42 guns produced was 46,572. Most were used during the military trials by the soldiers of the Leningrad Front. The military trials officially took place between January and April 1943.
Due to the massive investment already made in machinery for PPSh-41 production, which was already being produced in more than a million pieces per year, it turned out it would have been uneconomical to completely abandon its production in favor of the PPS. By end of the war some two million PPS-43 submachine guns were made. Due to the oversupply of the Soviet army with submachine guns after the war, production of the PPS in the Soviet Union ceased in 1946.
In the last two years of the war, Sudayev continued to experiment with improvements for his submachine gun. Six of his later prototype models, made in 1944 and 1945, are found in the Military Historical Museum of Artillery, Engineers and Signal Corps. These have variations in bolt shape and weight, as well as more obvious outward differences like a wooden, non-folding stock or a folding bayonet.
The PPS remained in service with some Soviet forces until the mid-1950s. Among the last to relinquish it were crews of armored vehicles and the Naval Infantry. Some World War II-era weapons found their way to the Chinese People's Liberation Army and were subsequently captured by UN forces in the Korean War.

Design details

Operating mechanism

The PPS is an automatic blowback-operated weapon that fires from an open bolt. The bolt is cylindrical in shape and contains a spring-loaded claw extractor, which pulls the empty case out of the chamber to be ejected. The ejector is mounted at the head of the recoil spring guide rod, which runs through a hole in the bolt. The charging handle is integral to the bolt and is located on the right side; it reciprocates during firing. Early versions of the PPS had a fixed but replaceable firing pin, held in place by the extractor spring. Pulling the trigger releases the bolt, which moves forward, stripping a round from the magazine, chambering it and striking the primer in one motion.

Features

The PPS has a trigger mechanism that allows only fully automatic fire and a manual safety that secured them against accidental discharges. When in the "safe" position, both the bolt and trigger are disabled.
The weapon is fed from curved 35-round box magazines. They are not interchangeable with magazines used in the PPSh-41, nor can the gun use drum magazines. It is chambered for the 7.62×25mm Tokarev M1930 pistol cartridge.
The submachine gun's rifled barrel is mounted in a perforated sheet metal heat guard and is equipped with a crude muzzle brake, consisting of a strip of steel bent into a U-shape that deflects exiting muzzle gases to the sides and backwards, thus compensating for recoil.
A folding stock is attached to the receiver with a spring-loaded catch button on the top. The stock folds up and over the receiver top cover and the weapon can be fired in this arrangement. The submachine gun also has a pistol grip but was not provided with a forward grip as the magazine well was intended to fulfil this role. The PPS was usually supplied with two magazine pouches, an oil bottle, bore brush and sling.
Even when compared to modern weapons, the PPS 43's simplicity of design and manufacture, along with its reliability and ease of use, and remarkably effective safety system, make it one of the best sub-machineguns ever made, in the eyes of many renowned firearms historians worldwide.

Sights

The PPS is fitted with a set of open-type iron sights consisting of a fixed front post protected from impact by two sheet metal plates and a flip rear sight with two pivoting notches, for firing at 100 and 200 m.

Variants