Mack TerraPro
The Mack TerraPro is a series of heavy duty and severe service trucks built by Mack Trucks. They are a forward control cab-over-engine type, where the driver sits in front of the axle. A flat front has two large windshields. A spotting feature is small notches in the lower inside of the windshields. It is used in refuse service and for construction concrete pumps.
A variant, the TerraPro Low Entry, with the cab mounted very low and forward, was renamed Mack LR in 2018.
Design
The TerraPro is a forward control cab-over-engine with a low cab in front of the axle. This allows very tight turning radius for the overall length of the truck. The low cab also lets a boom operate over it. There is an available right-side driving position. Commonly a 6x4 tandem steer front and extra lift axles are available. Total loaded weight can be up to on three or more axles.Advanced electronics are used for engine, chassis, and body controls, as well as maintenance. All trucks have ABS. Rear-view cameras are often fitted.
Mack builds their own major components and promotes an integrated design. Most vendor components are also available but engine choice is very limited.
Engines
The TerraPro is available with two Mack diesels and a Cummins Westport natural gas engine.The Mack MP7 engine is the base engine in the Granite. It is a overhead cam turbocharged inline six-cylinder engine. It develops and of torque.
The Mack MP8 engine is the largest engine in the TerraPro. It is a overhead cam turbocharged inline six-cylinder engine. It develops and of torque.
The Cummins Westport L9N is a natural gas engine. It is a turbocharged spark ignition inline six-cylinder engine. It develops and of torque.
Transmissions
Both Mack and Eaton-Fuller have manual and automated shifting models. Manual transmissions have five or six main gears, extra ratios are made with different combinations of ranges. Allison transmissions are fully automatic.Mack mDRIVE automated manual is the base transmission. It has no clutch pedal and shifts itself on demand. The driver can override it but it is normally driven in "D". It can have 12, 13, or 14-speeds. Other Mack manual transmissions have 8-18 speeds.
Eaton-Fuller UltraShift automated shifting systems are available on all of their transmissions from 9- to 18-speeds.
Allison RDS series 5- or 6-speed transmissions are used on most refuse trucks. The RDS is a fully automatic planetary gear transmission with a lock-up torque converter.
Transfer cases are used on concrete pumps. They direct full transmission output to either the drive-line or the pump, but not both.
Frame
A ladder frame with beam axles is used. Front axles are on semi-elliptical leaf springs and tandem steer axles are available. The base rear suspension is a Mack tandem but other axle/suspension available. Wheelbases are from. The TerraPro has more frame options than other Mack trucks.Dana-Spicer and Meritor supply air brakes, steering systems, driveshafts, and other components.
Axles and suspensions
Front axles are available from. Multi-leaf leaf springs are base, tapered leaves are optional. Springs have an eye mount at front but at the rear the spring goes through a solidly-mounted slipper. The slipper is stronger side to side than the typical shackle arrangement.Mack powered axles have the drive carrier on top of the housing instead of the front of it like other manufacturers. This lets the driveshafts be in line from the transmission to and between the axles at a higher level above the ground. With the higher level above the ground the driveshafts and u-joints are less prone to dirt and damage, important in on/off road construction.
Other powered axles are available from Dana-Spicer and Meritor. These have front mounted carriers and in tandems the two axle housings are different.
Single rear axles rated at are available from Mack and Meritor.
The Camelback tandem is the base rear suspension. The Camelback has multiple leaves that rock above the bogey pivot then curve down and under the axles. It is strong in on/off-road service. It is available in ratings of.
The mRIDE tandem has tapered leaves that rock above the bogey pivot then go out and above the axles. Struts go from the bottom of the bogey pivot out and under the axle. They have more wheel travel and ground clearance than the camelback. They are rated at.
Walking beams have low bogie pivots with a balance beam going out and under the axles. Any suspension is above the bogey pivot. Walking beams are very stable at low speeds and when stopped. Mack and Hendrickson models are available.
Vendor tandems from Chalmers, Hendrickson, Meritor, and RAYCO are rated at up to.
Applications
Refuse">Garbage truck">Refuse
Front loaders drive directly up to a container. A boom goes from the body over and then down in front of, the cab. As the truck moves forward slowly two forks pick up the container. The container is then lifted up and over the cab to be dumped into a hopper on the top of the body. Front loaders are used for commercial pickup.Side loaders drive next to bins placed on the curb. Most have a way to self-load from bins. Some have a low hopper between the cab and body. Others have an arm that picks up the bin, raises it up along the side of the body, then dumps it in a hopper on the top of the body. Side loaders are used for residential curb-side pickup. They have additional right side driving controls.
Rear loaders have a large hopper on the rear end. Typically a rear crew can load loose material, bins with assist, oversize pieces, and small containers. They are used for residential and light commercial pickup in congested cities.
Roll-off container trucks have a container that is raised in the front and slides off the back of the truck onto the ground. When a loaded box is carried it can be unloaded like a dump truck. They commonly haul construction debris but refuse containers are also left at commercial sites. TerraPros are sometimes used in congested cities when extreme maneuverability is required.
Construction
Concrete pumps have a multi-stage folding boom pivoted near the center of the truck and a hopper at the rear to load the pump. The pump itself is the load and the truck always operates at maximum weight. In transit the boom is folded front to rear. In use the pump uses outriggers and the boom unfolds forward over the cab or to either side. Large pumps can have multiple extra axles.Concrete conveyors have a telescopic conveyor belt. They do similar work to a pump but are limited and rarely as heavy as a pump.