The lorica squamata is a type of scale armour used by the ancient Roman military during the Roman Republic and at later periods. It was made from small metal scales sewn to a fabric backing. It is typically seen on depictions of standard bearers, musicians, centurions, cavalry troops, and auxiliary infantry, as well as regular legionaries. The Roman victory triumph depicting Trajan's victory over the Dacians, the Tropaeum Traiani, shows the majority of legionaries wearing loricae squamatae. A shirt of scale armour was shaped in the same way as a mail lorica hamata, mid-thigh length with the shoulder doublings or cape. This depiction may be in line with historical events, as Trajan had to re-equip his soldiers wearing lorica segementata with other forms of armor such as the lorica hamata and lorica squamata during the Dacian Wars. The individual scales were either iron or bronze, or alternating metals on the same shirt. They could be tinned as well, one surviving fragment showing bronze scales that were alternately tinned and plain. The metal was generally not very thick, 0.50 mm to 0.80 mm perhaps being a common range. Since the scales overlapped in every direction, however, the multiple layers gave good protection. The size ranged from as small as 6.3 mm wide by 9.5 mm tall up to about 5 cm wide by 8 cm tall, with the most common sizes being roughly 1.3 cm by 2.5 cm. Many have rounded bottoms, while others are pointed or have flat bottoms with the corners clipped off at an angle. The scales could be flat, or slightly domed, or have a raised midrib or edge. All the scales in a shirt would generally be of the same size; however, scales from different shirts may vary significantly. The scales were wired or laced together in horizontal rows that were then laced or sewn to the backing. Therefore, each scale had from four to 12 holes: two or more at each side for wiring to the next in the row, one or two at the top for fastening to the backing, and sometimes one or two at the bottom to secure the scales to the backing or to each other. There was also a rare type where the backing was a mail lorica hamata, effectively giving two layers of defence, but at the cost of greater weight and expense. It is possible that the shirt could be opened either at the back or down one side so that it was easier to put on, the opening being closed by ties. Much has been written about scale armour's supposed vulnerability to an upwardthrust, but this may be exaggerated. No examples of an entire lorica squamata have been found, but there have been several archaeological finds of fragments of such shirts and individual scales are quite common finds—even in non-military contexts. The type of armour in which the scales are laced to each other and need no backing at all is known as lamellar armour, while to confuse the matter there is also locking scale in which the scales are wired together without a backing. It can be difficult to tell which type of armour a single scale might have come from, as the Romans did not necessarily have different terms for each type. The typical scale had a vertical pair of holes at each side near the top, plus one or two holes at the top.
