A product of the last generation of cotton mill building, Leigh Spinners was designed by Bolton architects Bradshaw, Gass & Hope for the Horrocks Company, and built in two phases. The east section comprising the six-storey mill, boiler house and chimney stack was built in 1913 and the matching west section was completed ten years later. One of the few double mills to be completed, it is one of the most complete still standing in Greater Manchester. Part of the factory is occupied by Leigh Spinners Ltd who have manufactured carpets since 1969 and since 2012, synthetic turf products for landscaping and sport. The building is in poor condition and considered to be at risk by English Heritage. A charity, the Leigh Building Preservation Trust was formed to restore the steam engine and engine house. In September 2013 the charity was awarded a £75,000 grant to restore the steam engine and repair the engine house by Waste Recycling Environmental Limited, a heritage fund that protects buildings of historical importance. The charity was able to turn the engine in 2018 for the first time in many years. As at January 2019, the younger of the two mill buildings has had extensive roof repairs, allowing the Charity to advance the restoration of several floors. Sport England funding enabled the conversion of one floor to accommodate a Table Tennis Club, Indoor Bowls, Martial Arts, Cheerleading, Archery and a gym, with a cafe area and other facilities too. Further floors are now in development, with music studios and arts spaces already being established.
Structure
The mill has a reinforced steel frame clad in red brick with buff-coloured brick bands and dressings. The six-storey blocks are ten bays long and seven wide and have corner water towers. The water tower to the older 1913 block rises two stages above roof level and is topped with a cupola. Both blocks have offices, an engine house and rope race towers. The mill has a single chimney and the 1923 boiler house contains a cross compound mill engine made by Yates and Thom of Blackburn and once contained seven Lancashire boilers. The mill ran more than 200,000 mule and 4,800 ring spindles and its spinning machinery was supplied by Platt Brothers of Oldham.
