Guided bone and tissue regeneration


Guided bone regeneration and guided tissue regeneration are dental surgical procedures that use barrier membranes to direct the growth of new bone and gingival tissue at sites with insufficient volumes or dimensions of bone or gingiva for proper function, esthetics or prosthetic restoration. Guided bone regeneration typically refers to ridge augmentation or bone regenerative procedures; guided tissue regeneration typically refers to regeneration of periodontal attachment.
Guided bone regeneration is similar to guided tissue regeneration, but is focused on development of hard tissues in addition to the soft tissues of the periodontal attachment. At present, guided bone regeneration is predominantly applied in the oral cavity to support new hard tissue growth on an alveolar ridge to allow stable placement of dental implants. When Bone grafting is used in conjunction with sound surgical technique, guided bone regeneration is a reliable and validated procedure.

History

Use of barrier membranes to direct bone regeneration was first described in the context of orthopaedic research 1959. The theoretical principles basic to guided tissue regeneration were developed by Melcher in 1976, who outlined the necessity of excluding unwanted cell lines from healing sites to allow growth of desired tissues. Based on positive clinical results of regeneration in periodontology research in the 1980s, research began to focus on the potential for re-building alveolar bone defects using guided bone regeneration. The theory of Guided tissue regeneration has been challenged in dentistry.
The GBR principle was first examined by Dahlin et al. in 1988 on rats.
The selective ingrowth of bone-forming cells into a bone defect region could be improved if the adjacent tissue is kept away with a membrane; this was confirmed in a study by Kosopoulos and Karring in 1994.
GBR can be used for bone regeneration on exposed implant coils. Recent studies have shown greater attachment gain for guided tissue regeneration over open flap debridement. However, this systematic review has shown that the outcomes following GTR are highly variable, both between and within studies. Therefore, patients and health professionals need to consider the predictability of the technique compared with other methods of treatment before making final decisions on use.

Overview

Four stages are used to successfully regenerate bone and other tissues, abbreviated with the acronym PASS:
  1. Primary closure of the wound to promote undisturbed and uninterrupted healing
  2. Angiogenesis to provide necessary blood supply and undifferentiated mesenchymal cells
  3. Space creation and maintenance to facilitate space for bone in-growth
  4. Stability of the wound to induce blood clot formation and allow uneventful healing
After tooth removal, it takes 40 days for the normal healing process to take place.
The destructive gum condition, chronic periodontists, in the susceptible individual results in the breakdown of both the connective tissues which attach the tooth, and the bone supporting the root. Conventional treatment arrests the disease but does not regain bone support or connective tissue that was lost in the disease process. Guided tissue regeneration surgery can be applied here, aiming to regenerate the periodontal tissues.
A Cochrane review found that GTR had a greater effect on probing measures of periodontal treatment compared to open flap debridement.

Application

The first application of barrier membranes in the mouth occurred in 1982 in the context of regeneration of periodontal tissues via GTR, as an alternative to resective surgical procedures to reduce pocket depths.
Barrier membrane is utilized in GBR technique to cover the bone defect and create a secluded space, which prevents the connective tissue from growing into the space and facilitates the growth priority of bone tissue. An added benefit of the membrane is that it provides protection of the wound from mechanical disruption and salivary contamination.
Barrier membrane criteria should be as follows:
Several surgical techniques via GBR have been proposed regarding the tri-dimensional bone reconstruction of the severely resorbed maxilla, using different types of bone substitutes that have regenerative, osseoinductive or osseoconductive properties which is then packed into the bony defect and covered by resorbable membranes. In cases where augmentation materials used are autografts or allografts the bone density is quite low and resorption of the grafted site in these cases can reach up to 30% of original volume. Other materials available xenografts and autogenous bone. For higher predictability, nonresorbable titanium-reinforced d-polytetrafluoroethylene membranes—as a barrier against the migration of epithelial cells within the grafted site—are recommended. In patients with systemic problems interdisciplinary collaboration is indicated to adjust therapy background so that it does not adversely affect implanto-prosthetic treatment. Current treatments for destructive periodontal
disease are not able to restore damaged bone and connective tissue support for teeth. There are limitations in treating patients with advanced disease but GTR may be able to achieve regeneration and therefore improve upon conventional surgical results.
Currently there are two types of barrier membranes available; resorbable and non-resorbable.
Non-resorbable membranes:
The main types of non-resorbable barrier membranes are expanded polytetrafluoroethylene, high-density polytetrafluoroethylene, titanium mesh and titanium-reinforced PTFE.
Expanded polytetrafluoroethylene became the most common non-resorbable membrane used for bone regeneration in the 1990s. Gore-Tex was the most popular type of e-PTFE. The e-PTFE membrane is sintered with pores of 5 - 20 μm within the framework of the material. The e-PTFE membrane behaves as a barrier to prevent fibroblasts and various connective-tissue cells from entering the bone defect in order to allow the slower moving cells that are osteogenic to repopulate the defect. A study used e-PTFE membranes to cover surgically constructed average size bone defects in the mandibular angles of rats. Consequently, the e-PTFE membrane acted as a barrier to soft tissue and sped up bone healing, which took place between 3–6 weeks while no healing occurred in the non-membrane control group during a 22 week period.
The biological method of osteopromotion by exclusion is good for predicting ridge growth or defect regeneration.
Resorbable membranes:
There are many different types of resorbable membranes out there but the main ones are synthetic polymers and natural biomaterials. Synthetic polymers are such that it is a polylactic acid bilayer, or the collagen-derived membranes. These membranes can be obtained from bovine or porcine or dermis. E.g. Emdogain which has been shown to significantly improve probing attachment levels and periodontal pocket depth reduction when compared to a placebo or control materials. Resorption rates ranging from six to 24 weeks depending on its different chemical structures. With the resorbable membrane used, the membrane will bio-degrade. There is no need for a second surgery to remove the membrane, this will prevent any disruption to the healing process of the regenerated tissues. A synthetic resorbable membrane indicated an amount of stable augmented bone similar to that of a collagen resorbable membrane. These are the results obtained based on a randomised clinical trial done to compare the stability of augmented bone between a synthetic resorbable membrane and a collagen membrane with guide bone regeneration simultaneous with dental implant placement in the aesthetic zone in terms of facial bone thickness.
Success depends on osteoblasts being present at the site, there must be a sufficient blood supply, graft must be stabilised during healing and soft tissue must not be under tension.
is
There are several uses of bone regeneration:
Contraindication include:
Potential complications include: