Electromagnetic radiation and health
At sufficiently high flux levels, various bands of electromagnetic radiation have been found to cause deleterious health effects in people. Electromagnetic radiation can be classified into two types: ionizing radiation and non-ionizing radiation, based on the capability of a single photon with more than 10 eV energy to ionize atoms or break chemical bonds. Extreme ultraviolet and higher frequencies, such as X-rays or gamma rays are ionizing, and these pose their own special hazards: see radiation and radiation poisoning. The last quarter of the twentieth century saw a dramatic increase in the number of devices emitting non-ionizing radiation in all segments of society, which resulted in an elevation of health concerns by researchers and clinicians, and an associated interest in government regulation for safety purposes. By far the most common health hazard of radiation is sunburn, which causes between approximately 100,000 and 1 million new skin cancers annually in the United States.
Hazards
Extrinsic
Sufficiently strong electromagnetic radiation can cause electric currents in conductive materials that is strong enough to create sparks when an induced voltage exceeds the breakdown voltage of the surrounding medium. These can deliver an electric shock to persons or animals. For example, the radio emissions from transmission lines have occasionally caused shocks to construction workers from nearby equipment, causing OSHA to establish standards for proper handling.EMR-induced sparks can ignite nearby flammable materials or gases, which can be especially hazardous in the vicinity of explosives or pyrotechnics. This risk is commonly referred to as Hazards of Electromagnetic Radiation to Ordnance by the United States Navy. United States Military Standard 464A mandates assessment of HERO in a system, but USN document OD 30393 provides design principles and practices for controlling electromagnetic hazards to ordnance. The risk related to fueling is known as Hazards of Electromagnetic Radiation to Fuel. NAVSEA OP 3565 Vol. 1 could be used to evaluate HERF, which states a maximum power density of 0.09 W/m² for frequencies under 225 MHz.
Intrinsic
from electromagnetic fields can create a biological hazard. For example, touching or standing around an antenna while a high-power transmitter is in operation can cause severe burns. These are exactly the kind of burns that would be caused inside a microwave oven. The dielectric heating effect varies with the power and the frequency of the electromagnetic energy, as well as the distance to the source. The eyes and testes are particularly susceptible to radio frequency heating due to the paucity of blood flow in these areas that could otherwise dissipate the heat buildup.Radio frequency energy at power density levels of 1-10 mW/cm2 or higher can cause measurable heating of tissues. Typical RF energy levels encountered by the general public are well below the level needed to cause significant heating, but certain workplace environments near high power RF sources may exceed safe exposure limits. A measure of the heating effect is the specific absorption rate or SAR, which has units of watts per kilogram. The IEEE and many national governments have established safety limits for exposure to various frequencies of electromagnetic energy based on SAR, mainly based on Guidelines, which guard against thermal damage.
Low-level exposure
The World Health Organization began a research effort in 1996 to study the health effects from the ever-increasing exposure of people to a diverse range of EMR sources. After 30 years of extensive study, science has yet to confirm a health risk from exposure to low-level fields. However, there remain gaps in the understanding of the biological effects, and more research needs to be performed. Studies are being run to examine cells and determine if EM exposure can cause detrimental effects. Animal studies are being used to look for effects impacting more complex physiologies that are similar to humans. Epidemiological studies look for statistical correlations between EM exposure in the field and specific health effects. As of 2019, much of the current work is focused on the study of EM fields in relation to cancer.There are publications which support the existence of complex biological and neurological effects of weaker non-thermal electromagnetic fields, including weak ELF electromagnetic fields and modulated RF and microwave fields. Fundamental mechanisms of the interaction between biological material and electromagnetic fields at non-thermal levels are not fully understood.
Effects by frequency
While the most acute exposures to harmful levels of electromagnetic radiation are immediately realized as burns, the health effects due to chronic or occupational exposure may not manifest effects for months or years.Extremely-low frequency
Electric and magnetic fields occur where electricity is generated or distributed in power lines, cables, or electrical appliances. Human responses depend on the field strength, ambient environmental conditions, and individual sensitivity. 7% of volunteers exposed to power-frequency electric fields of high-power, extremely-low-frequency RF with electric field levels in the low kV/m range reported painful currents that flowed to ground through a body contact surface such as the feet, or arced to ground where the body was well insulated.A 2002 International Agency for Research on Cancer study measured the effect of ELF magnetic fields, and found “limited evidence” of human carcinogenicity in relation to childhood leukemia, leading the IARC to classify ELF magnetic fields as “possibly carcinogenic to humans”. The same study found “inadequate evidence” in relation to all other cancers. When IARC measured the effect of ELF electric fields, it found “inadequate evidence” for human carcinogenicity.
Shortwave
diathermy can be used as a therapeutic technique for its analgesic effect and deep muscle relaxation, but has largely been replaced by ultrasound. Temperatures in muscles can increase by 4–6 °C, and subcutaneous fat by 15 °C. The FCC has restricted the frequencies allowed for medical treatment, and most machines in the US use 27.12 MHz. Shortwave diathermy can be applied in either continuous or pulsed mode. The latter came to prominence because the continuous mode produced too much heating too rapidly, making patients uncomfortable. The technique only heats tissues that are good electrical conductors, such as blood vessels and muscle. Adipose tissue receives little heating by induction fields because an electrical current is not actually going through the tissues.Studies have been performed on the use of shortwave radiation for cancer therapy and promoting wound healing, with some success. However, at a sufficiently high energy level, shortwave energy can be harmful to human health, potentially causing damage to biological tissues. The FCC limits for maximum permissible workplace exposure to shortwave radio frequency energy in the range of 3–30 MHz has a plane-wave equivalent power density of mW/cm2 where f is the frequency in MHz, and 100 mW/cm2 from 0.3–3.0 MHz. For uncontrolled exposure to the general public, the limit is 180/f2 between 1.34–30 MHz.
Radio frequency field
The designation of mobile phone signals as "possibly carcinogenic to humans" by the World Health Organization has often been misinterpreted as indicating that some measure of risk has been observed however the designation indicates only that the possibility could not be conclusively ruled out using the available data.In 2011, International Agency for Research on Cancer classified mobile phone radiation as Group 2B "possibly carcinogenic". That means that there "could be some risk" of carcinogenicity, so additional research into the long-term, heavy use of mobile phones needs to be conducted. The WHO concluded in 2014 that "A large number of studies have been performed over the last two decades to assess whether mobile phones pose a potential health risk. To date, no adverse health effects have been established as being caused by mobile phone use."
Since 1962, the microwave auditory effect or tinnitus has been shown from radio frequency exposure at levels below significant heating. Studies during the 1960s in Europe and Russia claimed to show effects on humans, especially the nervous system, from low energy RF radiation; the studies were disputed at the time.
In 2019 reporters from the Chicago Tribune tested the level of radiation from smartphones and found it to exceed safe levels. The federal communications commission begun to check the findings.
Radio frequency radiation is found to have more thermal related effects. A person's body temperature can be raised which could result in death if exposed to high dosage of RF radiation. Focused RF radiation can also cause burns on the skin or cataracts to form in the eyes. Overall, some health effects are observed at a high levels of RF radiation, but the effects aren't clear at low levels of exposure.
Millimeter waves
In 2009, the US TSA introduced full-body scanners as a primary screening modality in airport security, first as backscatter x-ray scanners, which the European Union banned in 2011 due to health and safety concerns, followed by Millimeter wave scanners. Likewise WiGig for personal area networks have opened the 60 GHz and above microwave band to SAR exposure regulations. Previously, microwave applications in these bands were for point-to-point satellite communication with minimal human exposure.Infrared
wavelengths longer than 750 nm can produce changes in the lens of the eye. Glassblower's cataract is an example of a heat injury that damages the anterior lens capsule among unprotected glass and iron workers. Cataract-like changes can occur in workers who observe glowing masses of glass or iron without protective eyewear for prolonged periods over many years.Another important factor is the distance between the worker and the source of radiation. In the case of arc welding, infrared radiation decreases rapidly as a function of distance, so that farther than three feet away from where welding takes place, it does not pose an ocular hazard anymore but, ultraviolet radiation still does. This is why welders wear tinted glasses and surrounding workers only have to wear clear ones that filter UV.
Visible light
is damage to the macular area of the eye's retina that results from prolonged exposure to sunlight, particularly with dilated pupils. This can happen, for example, while observing a solar eclipse without suitable eye protection. The Sun's radiation creates a photochemical reaction that can result in visual dazzling and a scotoma. The initial lesions and edema will disappear after several weeks, but may leave behind a permanent reduction in visual acuity.Moderate and high-power lasers are potentially hazardous because they can burn the retina of the eye, or even the skin. To control the risk of injury, various specifications - for example ANSI Z136 in the US, EN 60825-1/A2 in Europe, and IEC 60825 internationally - define "classes" of lasers depending on their power and wavelength. Regulations prescribe required safety measures, such as labeling lasers with specific warnings, and wearing laser safety goggles during operation.
As with its infrared and ultraviolet radiation dangers, welding creates an intense brightness in the visible light spectrum, which may cause temporary flash blindness. Some sources state that there is no minimum safe distance for exposure to these radiation emissions without adequate eye protection.
Ultraviolet
Sunlight includes sufficient ultraviolet power to cause sunburn within hours of exposure, and the burn severity increases with the duration of exposure. This effect is a response of the skin called erythema, which is caused by a sufficient strong dose of UV-B. The Sun's UV output is divided into UV-A and UV-B: solar UV-A flux is 100 times that of UV-B, but the erythema response is 1,000 times higher for UV-B. This exposure can increase at higher altitudes and when reflected by snow, ice, or sand. The UV-B flux is 2–4 times greater during the middle 4–6 hours of the day, and is not significantly absorbed by cloud cover or up to a meter of water.Ultraviolet light, specifically UV-B, has been shown to cause cataracts and there is some evidence that sunglasses worn at an early age can slow its development in later life. Most UV light from the sun is filtered out by the atmosphere and consequently airline pilots often have high rates of cataracts because of the increased levels of UV radiation in the upper atmosphere. It is hypothesized that depletion of the ozone layer and a consequent increase in levels of UV light on the ground may increase future rates of cataracts. Note that the lens filters UV light, so if it is removed via surgery, one may be able to see UV light.
Prolonged exposure to ultraviolet radiation from the sun can lead to melanoma and other skin malignancies. Clear evidence establishes ultraviolet radiation, especially the non-ionizing medium wave UVB, as the cause of most non-melanoma skin cancers, which are the most common forms of cancer in the world. UV rays can also cause wrinkles, liver spots, moles, and freckles. In addition to sunlight, other sources include tanning beds, and bright desk lights. Damage is cumulative over one's lifetime, so that permanent effects may not be evident for some time after exposure.
Ultraviolet radiation of wavelengths shorter than 300 nm can damage the corneal epithelium. This is most commonly the result of exposure to the sun at high altitude, and in areas where shorter wavelengths are readily reflected from bright surfaces, such as snow, water, and sand. UV generated by a welding arc can similarly cause damage to the cornea, known as "arc eye" or welding flash burn, a form of photokeratitis.
Fluorescent light bulbs and tubes internally produce ultraviolet light. Normally this is converted to visible light by the phosphor film inside a protective coating. When the film is cracked by mishandling or faulty manufacturing then UV may escape at levels that could cause sunburn or even skin cancer.