The distance between the bore axis and the sight axis, also known as the sight height, is an important factor to consider due to parallax principles. It is normally desirable to keep the sights of a firearm as close to the bore as possible, since a firearm with a large bore-to-sight distance will require more sight adjustment when shifting between shooting at different targets at close ranges. On the other hand, a firearm with a short bore-to-sight distance will need less sight adjustment when changing between targets at close ranges. At longer ranges the bore to sight distance will be of less importance, since gravity has affected the projectile so much that the height difference between the bore axis and the sight axis has far less impact compared to the bullet drop. Traditional bolt hunting rifles usually have had the optical center of about above the bore, while AR-type rifles and modernbolt action rifles usually have their optical center about above the bore. On firearms with a picatinny rail, the distance from the bore to the optical axis can be divided into distance from bore axis to top of rail, and distance from top of rail to center of the optical axis. For example on an AR-type rifle, the mil-spec distance from center of bore to top of rail is 1.211 inches, or approximately. The mount height itself, that is the distance from the top of rail to center of scope, varies, but typically lies around . In total, this gives a typical scoped AR-style rifle a height over bore of around.
Recoil control
The recoil from a fired cartridge exerts a rearward impulse along the bore axis, which is commonly above the center of mass of the gun. Meanwhile, the grip areas of the gun, where the user will exert a reactive push against the recoil, is almost always below the gun's center of mass. This couple creates a rotational torque around the mass center and make the gun pitch upwards after each shot — a phenomenon known as muzzle rise. This is more prominent in shorter-barreled weapons such as handguns due to less weight available in front of the mass center to counter the upward rise of the muzzle, and how high the bore axis sits in relationship to the grip hand will also affect the degree of muzzle rise. A low-bore axis will make most of the recoil go directly into the hand, and thus give less muzzle rise. Among other things that affect muzzle rise and felt recoil is the weight of the pistol frame and tuning of recoil springs. The presence of buttstock in long guns will also help negate the effect of muzzle rise by shifting the pivot of the rise all the way to the butt end, thus utilizing the entire gun's weight with a longer lever to counter it.
Bore axis in pistols
Handguns lack a buttstock to aid in recoil control, so design elements that reduce felt recoil or muzzle flip are considered highly desirable and numerous manufacturers claim their handgun design has a low bore axis, although few offer measurements to prove this claim. While a lower bore axis does typically yield reduced felt recoil and muzzle flip, shooters intent on reducing these features as much as possible will typically seek out handguns with heavy steel frames, as increasing the weight of the gun's non-reciprocating mass yields greater reductions in felt recoil and muzzle flip than any difference in bore axis height can typically achieve. Handguns such as the CZ-75, which combine a heavy steel frame with a low bore axis achieve twofold reductions to felt recoil and muzzle flip, and are popular choices in many competitive shooting disciplines. Striker-fired handgun designs are typically able to achieve a lower bore axis than their hammer-fired counterparts since strikers travel straight forward, rather than up and forward like a typical hammer mechanism.
