The Barycentric Julian Date is the Julian Date corrected for differences in the Earth's position with respect to the barycentre of the Solar System. Due to the finite speed of light, the time an astronomical event is observed depends on the changing position of the observer in the Solar System. Before multiple observations can be combined, they must be reduced to a common, fixed, reference location. This correction also depends on the direction to the object or event being timed. In 1991, the BJD replaced the Heliocentric Julian Date, which reduced times to the centre of the Sun, which itself orbits the barycentre. The difference between HJD and BJD is up to ±4 s.
The correction is small for objects at the poles of the ecliptic. Elsewhere, it is approximately an annual sine curve, and the highest amplitude occurs on the ecliptic. The maximum correction corresponds to the time in which light travels the distance from the barycentre to the Earth, i.e. ±8.3 min.
Time Standard
JD and BJD are defined independent of the time standard. JD can be expressed as e.g. UTC, TT, TAI, TDB, etc. The differences between these time standards are of the order of a minute, so for better than one-minute accuracy, the time standard must be stated. While many quote the BJD in UTC, UTC is discontinuous and drifts with the addition of each leap second, and should therefore only be used for relative timing over a short timespan. For high-precision, absolute timing, TDB should be used. However, applications for which ±1.7 ms precision is sufficient may use TT to approximate TDB, which is much easier to calculate.
Calculation
Exact expression
Neglecting effects of special and general relativity, the correction of Terrestrial Time is where is the vector from the barycentre to the observer, is the unit vector from the observer to the object or event, is the distance from the observer to the observed object or event, and is the speed of light. This expression should be used for objects within the Solar System.
Expression for infinite distance
In the limit of infinite distance to the object, the exact expression becomes This expression should be used for objects beyond the Solar System. The error is at the level of 100 s for objects in the main asteroid belt, 5 s for Edgeworth-Kuiper Belt objects. At the distance of Proxima Centauri the accuracy is 1 ms.
Approximation for large distance
Due to the limited precision with which floating point numbers are stored in computers, the exact expression is in practice not accurate for large distances. The approximation is accurate for large distances. It should be used if the object is beyond the Solar System and if also millisecond accuracy is required.
