Aeronca Champion
The Aeronca Model 7 Champion, commonly known as the "Champ", or "Airknocker", is a single-engine light airplane with a high wing, generally configured with fixed conventional landing gear and tandem seating for two occupants.
Designed for flight training
and personal use—and specifically developed to compete with the popular Piper Cub, entered production in the United States in 1945, spawning one of the most popular, and longest-produced, light airplane models in the world.
In addition to the Champ's large-volume production by Aeronca Aircraft, it was revived in variations by the Champion Aircraft Company in the 1950s and 1960s, and then again in further variants by Bellanca in the 1960s and 1970s, and by American Champion Aircraft in the early 2000s.
To take advantage of the new light-sport aircraft category, the Champion was returned to production in 2007, but was discontinued by mid 2019.
Design and development
The Aeronca 7 Champion line—developed in the mid-1940s as a post-World War II response to the popular Piper J-3 Cub—uses similar design features, but also incorporates aspects of traditional Aeronca designs, including the internal main trusswork of the fuselage frame. Like its predecessors and initial rivals, the high-wing, two-seat plane has tandem seating, conventional landing gear, and a small piston engine.As with many light aircraft of the time, the Champ's fuselage and tail surfaces are constructed of welded metal tubing. The outer shape of the fuselage is created by a combination of wooden formers and longerons, covered with fabric. The cross-section of the metal fuselage truss is triangular, a design feature which can be traced all the way back to the earliest Aeronca C-2 design of the late 1920s.
The strut-braced wings of the Champ are, like the fuselage and tail surfaces, fabric-covered, and use aluminum ribs. Most Champs were built with wooden spars. American Champion has been using aluminum spars in the aircraft it has produced, and has also made the aluminum-spar wings available for retrofit installation on older aircraft.
Like the Piper Cub with which it competed, the Champ features tandem seating. However, while the J-3 model of the Cub is flown solo from the rear seat, the Champ can be soloed from the front, giving improved forward visibility, particularly on the ground and during takeoffs, landings, and climbs. The Champ offers far better visibility than the Cub, allowing 300 degrees of visibility to a front-seated pilot, and has a wider cabin than the Cub. Additionally, an uncommon Champ variant—the 7HC—was produced with an enlarged rear seat allowing 2 passengers to be carried.
The landing gear of most Champs is in a conventional arrangement, though two variants with tricycle gear were produced, and a model with reversed tricycle gear was tried. Conventional-gear Champs feature a steerable tailwheel and most have steel tube main gear which use an oleo strut for shock absorption. One variant utilized sprung-steel main gear, and American Champion uses aluminum gear legs in its production model of the Champ. Tricycle-gear Champs use the steel tube and oleo strut main gear, mating these with an oleo strut nose gear.
Models 7AC, 7CCM, 7DC, and 7EC were approved as floatplanes, with the addition of floats and vertical stabilizer fins; the floatplane versions were designated the S7AC, S7CCM, S7DC, and S7EC, respectively. The 7GC and 7HC may also be operated with floats but are not given a special designation in this configuration. All floatplane versions have increased gross weights over the corresponding landplanes.
Operational history
Built by Aeronca Aircraft Corporation, the Champ first flew in 1944, and entered production in 1945. As an economical postwar rival to the Piper Cub, the Champ was popular with training schools who were training veterans returning from World War II, by the thousands, with government funding through the G.I. Bill.The original model 7AC Champion initially sold by the thousands, peaking in 1946, as Aeronca developed the highest-volume production line in general aviation. Between 1946 and 1947, Aeronca was producing an average 30 light aircraft per day. But 1946 was a momentary explosion in lightplane production, industry-wide. The postwar boom-and-bust of the late 1940s and early 1950s brought an abrupt end to the massive sales, and—like the rest of the U.S. lightplane industry—Aeronca production dropped to a small fraction of 1946–1947 sales.
Engine upgrades in 1947, 1948 and 1949 resulted in the Models 7BCM, 7DC and the electric-system-equipped 7EC, all distinguished from the 7AC by a larger vertical tail than predecessors, to compensate for the greater torque and p-factor of the larger engines.
Some of these Champ variants were acquired by the U.S. Army Air Forces and its successor, the U.S. Air Force, particularly for use by the U.S. Army Ground Forces and the National Guard, as replacements for the Piper L-4 variant of the Piper Cub, used as an observation and liaison aircraft. The Aeronca Champ military variants were labeled L-16, L-16A and L-16B.
By the time production ended in 1951, the company had sold more than 8,000 Champions, mostly 7AC Champs.
Aeronca ceased all production of light aircraft in 1951, and the Champ design was sold in 1954 to Champion Aircraft, who continued production of some of the more advanced variants of the Champ, from the 1950s into the early 1960s—gradually modifying them into the aerobatic Champion Citabria.
Champion Aircraft was acquired in 1970 by Bellanca Aircraft which continued production of their Champ-derived Citabria and Decathlon designs.
In 1971, Bellanca introduced the 7ACA version of the Champ as a more basic complement to their other designs, as the least expensive, and lowest-performance, commercially produced light plane on the market at the time.
Only a handful of 7ACA's were built between 1971 and 1972. Bellanca ceased all production in the early 1980s.
American Champion Aircraft Corporation acquired the Champ and related designs in 1989. In 2001, they were rumored to be considering a reintroduction of the Champ design as a 7EC powered by a Jabiru Aircraft engine. While a test version was flown, this combination was not put into production. With the creation of the light-sport aircraft category of aircraft in the United States by the FAA, American Champion in late 2007 began producing a revised version of the 7EC powered by the Continental O-200-A. The new production aircraft are type certified, but also qualify to be flown by sport pilots in the United States. Although the fuselage and cowling contours are similar to the original-production models, the new aircraft used the windows, interior, door, and windscreen of the modern Citabria. Fuel capacity was reduced to to conserve weight; despite this measure and various others, such as the use of aluminum landing gear legs and bare birch floorboards rather than carpet, the aircraft's payload is inadequate to carry two adults and full fuel simultaneously. The manufacturer was considering various further weight-reduction measures including the use of the lightened Continental O-200D engine previously offered in the Cessna 162 Skycatcher. However, the revived 7EC was dropped from production by mid 2019.
Standard-production 7AC, 7BCM, 7CCM, 7DC, and 7ACA models qualify as U.S. Light Sport Aircraft. Only those specific original-production 7EC airplanes certificated at a gross weight qualify for the LSA category; a standard original-production 7EC is certificated at a gross weight of and does not qualify.
Variants
Various versions of the Champ have been tested and produced since 1944, including military, aerobatic, cropduster, tricycle-gear and a twin-engined variant.The derivative Citabria designs — models 7ECA, 7GCAA, 7GCBC, and 7KCAB — are discussed in a separate article, as is the twin-engined 402 Lancer. Floatplane variants are designated by an "S" prefix and are discussed together with the standard respective land variant.
7AC Champion
Introduced in 1945, the 7AC Champion was the first version of the design.It used the Continental A-65-8 engine of.
A supplemental type certificate allows the installation of a Lycoming O-235. The Champ featured a conventional landing gear configuration, with shock absorption in the main gear provided by oleo struts. The aircraft had no electrical system. It is distinguishable from nearly all other variants by the absence of a dorsal fin at the leading edge of the vertical tail. Approximately 7,200 were built between 1945 and 1948—far outnumbering all other subsequent variants combined,
and far outnumbering most rival designs of the period. Some were acquired by the U.S. military and designated L-16—not to be confused with the L-16A and L-16B derived from later Champ variants.
Gross weight is for the standard 7AC and when configured as an S7AC floatplane; fuel capacity for either version is in a single tank.
7ACA
1971 reintroduction by Bellanca, a modernized version of the design which made it a variant of the Citabria line. The 7ACA is powered by the two-cylinder Franklin 2A engine of ; Gross weight is. 71 were produced.7BCM, L-16A
Upgraded version introduced in 1947 with an Continental C85 and "no-bounce" version of the main landing gear. All of the 7BCM production went to the military as model L-16A. Gross weight and fuel capacity are unchanged from the 7AC. 509 were built.7B-X
Prototype, 1 produced, serial number 7-BX-1, FAA aircraft registration number was N4084E but registration was canceled on 4 October 1951, no other details known.7CCM, L-16B
An improved version of the L-16, the L-16B/7CCM featured a Continental C90-8 engine, an enlarged vertical tail, hydraulic brakes, and a gross weight increase to ; an additional gross weight increase to is allowed when "Long Stroke Oleo Landing Gear" is installed and placard, "Intentional spinning prohibited when baggage carried", is installed on the instrument panel. An additional fuel tank is used, increasing total fuel capacity to. Gross weight increases to when configured as an S7CCM floatplane. 100 L-16B/7CCM aircraft were built.7DC
Similar to 7CCM but with Continental C85 engine of ; the derived S7DC floatplane had a gross weight increase to. 100 7DC aircraft were produced.7EC Traveler
1950 brought the introduction of the Aeronca 7EC, which features a Continental C90-12F engine of, standard long-throw oleo strut main gear, thicker seat cushions, additional interior insulation for noise reduction, an improved heater and electrical system, the addition of a parking brake, and a change in center of gravity for enhanced speed. Advertised empty weight is. Standard gross weight is, or with "Lower End Landing Gear Oleo Strut Assembly." Standard fuel capacity is unchanged from the 7DC; an optional system was offered, increasing the manufacturer's empty weight by. The optional S7EC floatplane configuration has a gross weight of.The last Champ produced at Aeronca was a 7EC, and when Champion reintroduced the Champ in 1955, it was with their version of the 7EC, very little changed from Aeronca's. An enhanced version called the Champion DeLuxe Traveler offered a metal propeller with spinner, wheel pants, a steerable tailwheel, and navigation lights.
773 7EC aircraft were produced during the original production run.
In late 2007, American Champion introduced a revised version of the 7EC, featuring the Continental O-200-A engine of. Differing in a number of ways from earlier 7ECs, this new version in particular replaced the wood-spar wings of the earlier versions with a metal-spar wing and used aluminum gear legs. To fit within the Light Sport requirements, the maximum weight was reduced to 1,320 pounds. The aircraft was discontinued by mid 2019.
7FC Tri-Traveler
In 1957, Champion brought out the 7FC, which is similar to the 7EC but with tricycle landing gear instead of conventional gear, oleo struts on all 3 wheels, and extra frame bracing for the nosewheel. Factory standard equipment was comparable to the 7EC DeLuxe Traveler. The 7FC is slower and heavier than an equivalent 7EC, with a standard useful load of, compared with for the 7EC; both use the Continental C90-12F engine. Standard gross weight of the 7FC is with an increase to allowed with the installation of "Wide Track Main Gear."472 7FC aircraft were built.