An aeronautical chart is a map designed to assist in navigation of aircraft, much as nautical charts do for watercraft, or a roadmap for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful information such as radio frequencies and airspace boundaries. There are charts for all land masses on Earth, and long-distance charts for trans-oceanic travel. Specific charts are used for each phase of a flight and may vary from a map of a particular airport facility to an overview of the instrument routes covering an entire continent, and many types in between. Visual flight charts are categorized according to their scale, which is proportional to the size of the area covered by one map. The amount of detail is necessarily reduced when larger areas are represented on a map.
World aeronautical charts have a scale of 1:1,000,000 and cover relatively large areas. Outside of WAC coverage, operational navigation charts may be used. They use the same scale as WACs, but omit some useful information such as airspace restrictions.
Sectional charts typically cover a total area of about 340x340 miles, printed on both sides of the map. The scale is 1:500,000.
VFR Terminal area charts are created with a scale and coverage appropriate for the general vicinity of a large airport. They may depict preferred VFR flight routes within areas of congested airspace.
When an aircraft is flying under instrument flight rules, the pilot will often have no visual reference to the ground, and must therefore rely on internal or external aids in order to navigate. Although in some situations air traffic controlmay issue radar vectors to direct an aircraft's path, this is usually done to facilitate traffic flow, and will not be the sole means of navigating to an important point, such as the position from which an aircraft commences its approach to landing. Charts used for IFR flights contain an abundance of information regarding locations of waypoints, known as "fixes", which are defined by measurements from electronic beacons of various types, as well as the routes connecting these waypoints. Only limited topographic information is found on IFR charts, although the minimum safe altitudes available on the routes are shown. En-route low- and high-altitude charts are published with a scale that depends upon the density of navigation information required in the vicinity. Information from IFR charts is often programmed into a flight management system or autopilot, which eases the task of following a flight plan. Terminal procedure publications such as Standard Terminal Arrival plates, Standard Instrument Departure plates and other documentation provide detailed information for arrival, departure and taxiing at each approved airport having instrument capabilities of some sort.
