14-pounder James rifle


The 14-pounder James rifle or James rifled 6-pounder or 3.8-inch James rifle was a bronze muzzle-loading rifled cannon that was employed by the United States Army and the Confederate States Army during the American Civil War. It fired a solid shot up to a distance of at 5° elevation. It could also fire canister shot and common shell. Shortly before the war broke out, the U.S. Army adopted a plan to convert M1841 6-pounder field guns from smoothbore to rifled artillery. Rifling the existing 6-pounders would both improve the gun's accuracy and increase the weight of the shell. There were two major types produced, both were bronze with a bore of that would accommodate ammunition designed by Charles Tillinghast James. The first type looked exactly like an M1841 6-pounder field gun. The second type had a longer tube with a smooth exterior profile similar to a 3-inch Ordnance rifle. At first the rifles were quite accurate. However, it was discovered that the bronze rifling quickly wore out and accuracy declined. None of the rifles were manufactured after 1862, and many were withdrawn from service, though some artillery units employed the guns until the end of the war.

Background

invented cotton-mill machinery, then was elected Senator from Rhode Island in 1851–1857. He subsequently became a militia major general from Rhode Island and began creating projectiles suitable for rifled artillery. James was a close friend of James Tyler Ames, the owner of the Ames Manufacturing Company, so it followed that Ames forged most of the weapons that became known as James rifles. General James died in October 1862 when a new shell he was testing accidentally exploded. On 1 November 1860 a U.S. Army board recommended that half of the existing smoothbore cannons in forts and arsenals should be rifled according to the plan of General James. Accordingly, Secretary of War John B. Floyd wrote Lieutenant Colonel William J. Hardee on 14 December 1860, "I have to state that the results of trials of rifled cannon and projectiles, under the direction of this department, indicates a superiority of James expanding projectiles for such cannon. The regulation 6-pounder, with a rifled bore, carries a James projectile of about 13 pounds." Floyd pointed out that rifling the older guns to accommodate the James shells would inexpensively double the weight of shell fired, since the shells were elongated. Floyd believed this could be done without putting too much stress on the gun barrel.
The caliber gun was commonly known as the 14-pounder James rifle, while a caliber gun was often referred to as a 12-pounder James rifle or a rifled 6-pounder. At the time, people generally failed to differentiate between the two. Actually, the 3.8-inch artillery piece was manufactured with three different types of rifling, and more than one metal and profile. Because many of the U.S. Army's existing 3.67 inch caliber 6-pounders had worn-out bores, it was found that re-boring the guns to 3.8 inch caliber would make them a uniform size. On 15 December 1860, General James signed a contract that required him to rifle half of the cannons at United States arsenals and forts. Unfortunately, there is no surviving paperwork that shows to what extent this contract was carried out. Any records are supposed to have been lost.
Late in 1861, the Ames Company received an order to produce several 6-pounder smoothbore guns and 3.8-inch rifles. These were to be called "new model" or Model of 1861. By this time, gun makers discovered that any irregularity on the exterior of a cannon was a possible source of fracture. Therefore, the "new model" guns were designed with a smooth exterior surface. Ten 6-pounder James smoothbores are known to exist. The 3.8-inch rifles became known as James rifles because they were designed to fire the James projectiles. It is important to note that when General George B. McClellan inquired about James rifles, Secretary of War Edwin Stanton responded by writing, "James is not known as a manufacturer of guns, and it is not known that he makes any pretense of having invented one. Ames, of Chicopee, manufactures guns, and is the manufacturer of James projectiles..."

Specifications

Authors James C. Hazlett, Edwin Olmstead, and M. Hume Parks describe the 3.8-inch re-bored and rifled M1841 6-pounder field guns as Type 1 and the "new model" 3.8-inch James rifles as Type 2. The gun carriage for 12-pounder James rifles weighed.

Type 1

The bronze pieces called Type 1 all have the external appearance of a Model 1841 6-pounder field gun, caliber, 15-groove rifling of right-hand twist, and a weight of about. More than 70 of the Type 1 rifles survive today, all except one are bronze. They are as follows. Of 6-pounders dated from 1842 up until 1861, and later rifled as Type 1, Ames produced 15 and Cyrus Alger Company produced eight. Of 6-pounders dated 1861 and 1862, and rifled as Type 1, Ames manufactured 25 and Greenwood Company manufactured 27. There is one surviving Type 1 of Confederate origin, produced by Skates and Company of Mobile, Alabama. Finally, there is one surviving cast iron Type 1 that was originally manufactured by Alger in 1854.
The Type 1 14-pounder James rifle has dimensions identical to the M1841 6-pounder field gun. The barrel length, excluding the knob, is, the bore length is, the reinforce length is, and the base ring diameter is. There was no official table of fire for Type 1 14-pounder James rifles. However, Henry Larcom Abbot published test ranges that were compiled by A. P. Rockwell of the 1st Connecticut Light Artillery Battery. Using a gunpowder charge that weighed, a Type 1 fired a Schenkl shell a distance of at an elevation of 5° and a Hotchkiss shell a distance of at an elevation of 5°.

Type 2

The bronze Type 2 14-pounder James rifle had a smooth exterior form similar to a 3-inch Ordnance rifle and an average weight of. The Type 2, Series 1 had seven-groove rifling and a weight of, of which only five guns survive. Only Series 1 and 2 guns were stamped JAMES RIFLE CANNON on the reinforce near the vent. There are six surviving Series 2 guns, 16 surviving Series 3 guns, and 53 surviving Series 4 guns. Series 2 guns weigh an average of, Series 3 guns weigh, and Series 4 guns weigh. Series 2, 3, and 4 all had 10 rifling grooves of right-hand twist. Various muzzle, trunnion, and breech stampings account for the other differences between Series 1, 2, 3 and 4 guns.
The Type 2 14-pounder James rifle measured from muzzle to the end of the knob and from muzzle to base, excluding the knob. Its bore length was and it measured from muzzle to vent. The trunnions had a diameter of and the distance between the ends of the trunnions was. The gun measured from the muzzle to the center of the trunnions. The gun barrel was wide at the breech and wide at the muzzle. The breech had a hole to which a stadia sight could be attached. The bore was.

Other

Hazlett, Olmstead, and Parks tentatively identify a Type 3 14-pounder James rifle that was made of cast steel. A record exists of a purchase order for Ames to manufacture six cast steel guns totaling or about each. There are three painted steel 3.8-inch rifled guns at Shiloh National Military Park that appear to match the purchase order. The guns have the same Ordnance profile as the Type 2 bronze rifles, but there is also a thicker band across the trunnions. There are 10 rifle grooves of right-hand twist. Every single type and series of James rifle listed above can be found at Shiloh National Military Park.
TypeShapeMetalCaliberRifle GroovesTube WeightNo. Survivors
Type 1M1841 6-pounderBronze3.8 inch15880 lbs.76
Type 2 Series 1Ordnance ProfileBronze3.8 inch7928 lbs.5
Type 2 Series 2Ordnance ProfileBronze3.8 inch10922 lbs.6
Type 2 Series 3Ordnance ProfileBronze3.8 inch10918 lbs.16
Type 2 Series 4Ordnance ProfileBronze3.8 inch10917 lbs.53
Type 3Ordnance Profile with Trunnion BandCast Steel3.8 inch10unknown3

Battery composition

The typical Union Army battery was armed with six guns. A team of six horses pulled each gun plus a limber which included one ammunition chest. Each gun had an additional six-horse team that pulled one caisson plus a limber which had three ammunition chests. Each battery had one traveling forge, one tools and equipment wagon, and spare horses. A gun platoon was made up of a sergeant, two corporals, six privates, and six drivers. The first nine men crewed the gun. Two platoons made a section led by a lieutenant and the battery was commanded by a captain. Attached to each battery were an adjutant, first sergeant, quartermaster sergeant, five artificers, two buglers, and one guidon-bearer. Confederate batteries were organized similarly.

History

The 12-pounder James rifles suffered from two disadvantages. First, the rifling wore out quickly which reduced the gun's accuracy. Second, the higher pressures in the gun barrel by the rifling severely strained the breech, causing the James rifles to frequently burst when fired. Because of these problems, many of the guns were withdrawn from service fairly early in the conflict. The guns achieved great accuracy when test fired, but the bronze rifling degraded fairly quickly. The premature death of General James may have played a part in the guns being discarded. In any case, none were produced after 1862.
At the Battle of Pea Ridge on 7–8 March 1862, Louis Hoffman's 4th Ohio Battery was armed with what is described as four 12-pounder James rifles and two M1841 12-pounder howitzers. In the first day's fighting at Leetown, the Ohio battery drove off the 6th Texas Cavalry Regiment. The 4th Ohio Battery took part in Franz Sigel's highly successful artillery bombardment on the second day. Another source specifically stated that the 4th Ohio Battery was, in fact, armed with four 3.8-inch James rifles as late as the third quarter of 1863. At that date, the 2nd Ohio, 3rd Ohio, 7th Ohio, and 10th Ohio Batteries all had four 3.8-inch James rifles, and the 5th Ohio Battery was armed with two 3.8-inch James rifles.
At the Battle of Antietam on 17 September 1862, the 1st Ohio Battery commanded by Captain James R. McMullin was attached to the Kanawha Division in the Union IX Corps. We know that the battery was armed with six 14-pounder James rifles because McMullin specifically referred to 3.800 inch guns in his after action report. By 1 October 1862, the battery was re-equipped with six 3-inch Ordnance rifles. McMullin wrote that the battery was posted within of Burnside's Bridge and fired on Confederate infantry and artillery at a distance of. At 3:00 pm the battery was withdrawn because it was impossible to obtain a resupply of ammunition. The 8th Massachusetts Light Artillery, also in IX Corps, was equipped with four James rifles, but it is not known if their caliber was 3.8 inch or 3.67 inch. These were the only ten James rifles employed by the Union Army of the Potomac at Antietam; it is not recorded if the Confederate Army of Northern Virginia had any.
A few weeks later at the Battle of Perryville on 8 October 1862, the Union Army of the Ohio used 23 14-pounder James rifles out of a total of 147 guns. In the Confederate Army of Mississippi, there were only two 14-pounder James rifles out of 56 total guns. Both rifles were in Henry C. Semple's Alabama Battery. Of the Union guns that were in action, there were two 14-pounder James rifles each in Asahel K. Bush's 4th Independent Battery Indiana Light Artillery, Peter Simonson's 5th Independent Battery Indiana Light Artillery, David C. Stone's Battery "A" Kentucky Light Artillery, and Charles M. Barnett's Battery "I", 2nd Illinois Light Artillery Regiment. In each of the four engaged batteries there were three different types of cannon. For example, Stone's Battery consisted of two M1841 6-pounder field guns, two 10-pounder Parrott rifles, as well as the two 14-pounders.
On the Union side, there was a migration of less-preferred cannons from the Eastern Theater to the Western Theater of the American Civil War. By the time of the Battle of Gettysburg was fought in the east on 1–3 July 1863, the Army of the Potomac employed only four James rifles. Yet on 30 June 1863, the western Army of the Cumberland still had 45 3.8-inch James rifles in its inventory, second only in numbers to its 60 12-pounder Napoleons. Other guns included 34 3-inch Ordnance rifles, 32 10-pounder Parrott rifles, 24 M1841 6-pounder field guns, 10 M1841 12-pounder howitzers, and nine other artillery pieces. In the small Army of the Ohio, there were 26 3.8-inch James rifles, 18 12-pounder Napoleons, 12 3-inch Ordnance rifles, and 16 other guns.
Cogswell's Battery Illinois Light Artillery was armed with four 3.8-inch James rifles as late as August 1864 when the unit garrisoned Nashville, Tennessee. In December 1863, the Springfield Illinois Light Artillery also had four 3.8-inch James rifles, while Henshaw's Battery Illinois Light Artillery and the Chicago Board of Trade Battery each had two 3.8-inch James rifles.

Civil War artillery

DescriptionCaliberTube lengthTube weightCarriage weightShot weightCharge weightRange 5° elev.
M1841 6-pounder cannon
M1841 12-pounder cannon
M1841 12-pounder howitzer
M1841 24-pounder howitzer
M1857 12-pounder Napoleon
12-pounder James rifle
3-inch Ordnance rifle
10-pounder Parrott rifle
20-pounder Parrott rifle